802.11-Wireless-Networks

一个相对完整的OFDM通信系统的仿真设计，包括编码，调制，IFFT，上下变频，高斯信道建模，FFT，PAPR抑制，各种同步，解调和解码等模块，并统括系统性能的仿真验证了系统设计的可靠性。(OFDM： coding modulation IFFT AWGN Mode FFT ……)

水声探测技术中时反结合mimo提高探测性能的matlab仿真(Anti combined mimo method to improve detection performance underwater acoustic detection technologies.)

qpsk在高斯信道下的仿真，包括误码率和仿真图(Simulation of QPSK in Gaussian channel)

STIM300高精度IMU的输出解码程序，MOD93格式，带CRC校验，直接可以运行(MOD93 format with a CRC check can be run directly)

说明：  bpsk调制仿真，可直接用 1、数字调制方法 数字调制就是把数字基带信号的频谱搬移到高频处，形成适合在信道中传输的带通信号。基本的数字调制方式有振幅键控（ASK）、频移键控（FSK）、绝对相移键控（PSK）、相对（差分）相移键控（DPSK）。在接收端可以采用想干解调或非相干解调还原数字基带信号。 数字信号的传输方式分为基带传输和带通传输。然而，实际中的大多数信道（如）无线信道具有丰富的低频分量。为了使数字信号在带通信道中传输，必须用数字基带信号对载波进行调制，以使信号与信道的特性相匹配。(1, digital modulation method Digital modulation is the transfer of the spectrum of a digital baseband signal to a high frequency to form a bandpass signal suitable for transmission in the channel. The basic digital modulation methods are amplitude keying (ASK), frequency shift keying (FSK), absolute phase shift keying (PSK), and relative (differential) phase shift keying (DPSK). At the receiving end, the digital baseband signal can be restored by using dry demodulation or non-coherent demodulation. Digital signal transmission methods are divided into baseband transmission and bandpass transmission. However, most channels in practice, such as wireless channels, have rich low frequency components. In order for a digital signal to be transmitted in a band channel, the carrier must be modulated with a digital baseband signal to match the signal to the characteristics of the channel.)

说明：  matlab基础入门，适合新手学习matlab基础操作与功能(Introduction to matlab)

OFDM系统，包括系统的编码，调制，转换，发送，时间同步，频率同步(OFDM systems, including system encoding, modulation, conversion, send, time synchronization, frequency synchronization)

关于GSM中同频干扰和邻频干扰的分析，和matlab仿真实现，有图(About the GSM co-channel interference and adjacent channel interference analysis, and matlab simulation, a map)

MATLAB实现了HARQ重传，分析误码率和信噪比间的关系，并可以修改最大重传次数(MATLAB implements the retransmission of HARQ, analyzes the relationship between the bit error rate and the signal to noise ratio, and can modify the maximum retransmission times.)

说明：  此文档中主要说明了基于Matlab的时间抽取基2FFT算法的一些注意事项以及程序是可行的。(In this document mainly describes the time taken based on the Matlab-based algorithm 2FFT some attention as well as the procedure is feasible.)