4.面阵中二维角度估计 Unitary -ESPRIT算法MATLAB

QAM调制的误码率仿真代码，通俗易懂，简单实用。(The error rate simulation code of QAM modulation is easy to understand, simple and practical.)

手机GSM TI 平台 串口 uart 驱动 源代码(Serial port uart driver source code of mobile phone GSM TI platform)

OPNET软件自带的General Tutorial中文译版，学习OPNET非常实用!(OPNET software s own version of Chinese Translation General Tutorial, learning OPNET very useful!)

Optimal Resource Allocation and EE-SE Trade-Off in Hybrid Cognitive Gaussian Relay Channels

GSM链路级仿真程序，按照基本GSM规范编写而成。(GSM link level simulation program, written in accordance with the basic GSM standard.)

在LDPC译码中用LLR方式,跌代次数分别为5和10对译码性能的影响MATLAB写的()

说明：  这是一个通信的Nakagami算法，理论值和仿真结果全都有，希望对大家有帮助。(This is a Nakagami algorithm for communication. Both theoretical and simulation results are available. I hope it will be helpful to you all.)

实用性代码，可以在手机等移动设备上很好的使用，可操作性强。(Usefulness of the code can be very good for use on mobile phones and other mobile devices operable.)

The PCI Local bus concept was developed to break the PC data I/O bottleneck and clearly opens the door to increasing system speed and expansion capabilities. The PCI Local bus moves high speed peripherals from the I/O bus and places them closer to the system’s processor bus, providing faster data transfers between the processor and peripherals. The PCI Local bus also addresses the industry’s need for a bus standard which is not directly dependent on the speed, size and type of system processor. It represents the first microprocessor independent bus offering performance more than adequate for the most demanding applications such as full-motion video.(The PCI Local bus concept was developed to breakthe PC data I/O bottleneck and clearly opens the doorto increasing system speed and expansion capabilities.The PCI Local bus moves high speed peripheralsfrom the I/O bus and places them closer to the system sprocessor bus, providing faster data transfersbetween the processor and peripherals. The PCI Localbus also addresses the industry s need for a bus standardwhich is not directly dependent on the speed, size and type of system processor. It represents thefirst microprocessor independent bus offering performancemore than adequate for the most demandingapplications such as full-motion video.)

该工程实现对单载波系统QPSK的频偏估计算法。调相信号在接收机相干解调时需要同频同相的参考载波，而发射机和接收机之间往往存在频率偏差，为了消除这种误差，必须在软件层面实现。使用了QPSK四相调制的信号特点进行载波频偏估计，经验证，效果较好。(This project implements frequency offset estimation algorithm for single carrier system QPSK. The phase modulation signal needs the same frequency reference carrier in the coherent demodulation of the receiver, and the frequency deviation often exists between the transmitter and the receiver. In order to eliminate this error, it must be implemented on the software level. The carrier frequency offset estimation is carried out by using the signal characteristics of QPSK four phase modulation.)