CHENGXU

The contents of the present document are subject to continuing work within the TSG and may change following formal TSG approval. Should the TSG modify the contents of the present document, it will be re-released by the TSG with an identifying change of release date and an increase in version number.

A New Algorithm for Joint Range-DOA-Frequency Estimation of Near-Field Sources

ADIBEAM Abstract—the increase in navigation accuracy demanded by EGNOS and Galileo and their future evolution encourages the study and design of advance receiver architectures. In that direction, the ADIBEAM project focuses on the design of high accuracy ground stations, specifically GNSS Reference Stations, in order to improve its robustness in front of multipath and interference errors with the goal of achieving centimeter level tracking accuracy. The adoption of antenna arrays and digital beamforming at the ground reference station receivers is one of the most promising approaches to cope with errors induced by multipath and interference.

本文作的工作是利用信号仿真器仿真GPS数字中频信号，并借助这些仿真信 号完成对GPS信号的捕获和跟踪性能的研究。(This article is for the use of GPS signal simulator simulation digital IF signal, and make use of these simulation signal completion of the GPS signal acquisition and tracking performance study.)

中国移动通信互联短信网关接口协议CMPP3(CMPP3)

si4432射频芯片的中文开发资料，寄存器配置等(the si4432 radio frequency chip Chinese development information, register allocation)

争对移动声源采用波束形成进行语音增强，提出一种约束子带波束形成算法。其波束形成器基于一个软约束，其目的是要使波束指向特定的区域即声源方向。而其核心在于首先要进行声源定位，获得尽量准确的方位信息，然后构造软约束条件，用于波束形成。且在此过程中不断跟踪声源的移动情况。在构造的约束条件中，需要知道声源的二维信息，即与麦克风阵列的距离和方向角，“软”体现在对距离和方向角的确定都是在一定范围内的，有待进一步更正。(Between the mobile sound source using beamforming for speech enhancement, a constrained subband beamforming algorithm. Its beamformer based on a soft constraints, the aim is to make the beam point to a specific region that is the direction of the sound source. And its core is the first to sound source location, access to location information as accurately as possible, and then construct the conditions of soft constraints for beamforming. And in the process continuously tracking the movement of a sound source. Structure at the binding conditions, need to know the two-dimensional sound source information, that is, with the microphone array the distance and direction angle, the " soft" embodied in the distance and direction angle of the determination are within the scope must be further corrected .)

说明：  S7200 通过modbus 通讯与多块表通讯 定时轮询(Reading multi block instrument timing polling)

宽带射频功率放大器的数字预失真技术研究论文，学习资料(Broadband rf power amplifier digital predistortion technology research )

主要是实现调制识别，区分几种常用的数字调制信号。含有两个文件夹 其一为特征参数的仿真；其二为正确识别率的仿真。文件夹key feature simulink中： 运行程序会得到各特征参数之间区分图 从图中可看到特征参数的有效性，见图。 文件夹classification rate simulink中：运行main.m文件 可以得到正确识别率 见图。(It is mainly to realize modulation recognition and distinguish several commonly used digital modulation signals. The simulation of two folders is one of the characteristic parameters, and the second is the simulation of the correct recognition rate. In the folder key feature Simulink: The running program will get the validity of the feature parameters that can be seen from the diagram, as shown in the diagram. Folder classification rate Simulink: running the main.m file can get the correct recognition rate.)