1.迹线法

修改原来的六步支付过程为一页支付.改善体验.(Modify the original payment process to pay for one page.)

设计一个8位的简易频率计，测出信号的频率，即1s内变化的次数。(An 8-bit simple frequency meter is designed to measure the frequency of the signal, i.e. the number of changes in one second.)

说明：  基于辨识的ARMAX模型，进行GPC广义预测控制研究(Research on GPC generalized predictive control based on the identified ARMAX model)

说明：  基于结构光相移法的三维重建程序，matlab编码，由于要的可以下载一下(Based on the structured light phase-shift method of three-dimensional reconstruction program, matlab coding, because you can download it)

java软件考试题库，可以查看历年真题，帮您轻松过软考(Java software examination question bank)

说明：  SS9 型客运电力机车主变流器设计matlab仿真模型(Matlab simulation model for main converter design of SS9 passenger electric locomotive)

说明：  AR程序设计4，扫描图片可以出现三维模型，并操作(AR programming 4, scanning pictures can appear three-dimensional model, and operation)

About wireless sensor network and routing protocols

很好的c语言习题解答-good language to answer the questions

1、PC和寄存器组使用时钟触发。 2、指令存储器和数据存储器存储单元宽度一律使用8位，即一个字节的存储单位。 3、控制器部分可以考虑用控制信号真值表方法（有共性部分）与用case语句方法逐个产生各指令其它控制信号相配合，注意：信号必须与状态配合。。当然，还可以用其它方法，自己考虑。 4、试用的汇编程序，而且必须包含所要求的所有指令。Slt、sltu指令必须检查两种情况：“小于”和“大于等于”；beq、bne指令必须检查两种情况：“等”和“不等”。这段汇编程序必须尽量优化，同时，给出每条指令在内存中的地址。(1, PC and register groups are clocked. 2, the command memory and data memory storage unit width will use 8 bits, that is, a byte storage unit. 3, the controller part can be considered with the control signal truth table method (common part) and with the case statement method to produce each command other control signal match, Note: the signal must be with the state. The Of course, you can also use other methods to consider their own. 4, try the assembler, and must contain all the required instructions. Slt, sltu instruction must check two cases: "less than" and "greater than or equal to"; beq, bne instruction must check two cases: "wait" and "unequal". This assembler must be optimized as much as possible, giving the address of each instruction in memory.)