汽车行业CAN通讯SAEJ1939标准英文版

the matlab file gives LS, MMSE, LMMSE channel estimation for wireless channel, very short and good

si4432射频芯片的中文开发资料，寄存器配置等(the si4432 radio frequency chip Chinese development information, register allocation)

一篇北京邮电大学的博士论文。蜂窝网协作通信及相关技术研究 2010。关键词:协作通信，蜂窝网，多入多出，正交频分复用，频率复用系数，中继 (A Beijing University of Posts and Telecommunications doctoral thesis. Cellular communications and related technology research collaboration 2010. Keywords: cooperative communication, cellular network, multi-input, multiple output, orthogonal frequency division multiplexing, frequency reuse factor, relay)

关于polar codes的源码，简单的仿真。(An Brief Introduction to Polar Codes)

匹配滤波器的实现。主要是通过fft变化使输出自相关最大，在通过滤波器。(Matched filter implementation. Mainly through changes in the output autocorrelation fft the largest through the filter.)

cooperative relay communication ieee

说明：  该程序给出了利用Saleh模型进行功率放大器预失真的过程．(The program gives the power amplifier pre-distortion with Saleh models.)

TO PLOT THE RAYLEIGH DISTRIBUTION PLOT

利用matlab simulink产生两路模拟语音信号，经过pcm编码、时分复用、DPSK调制经过同一个信道单向传输到对应的接收端。常用的三个模块 simulink、通信模块、信号处理模块。包括课程设计报告。(Using matlab simulink produce two analog voice signals through the pcm encoding, time division multiplexing, DPSK modulation over the same one-way transmission channel to a corresponding receiver. The three modules used simulink, communication module, a signal processing module. Including curriculum design report.)

说明：  对当前通信信号中常用的数字调相信号BPSK、QPSK、1／4一QPSK、8PSK的调制识别问题，提出了一种基于信号差分高阶累积量的识剐算法。该算法分两个层次进行调制识别，首先利用信号的四阶累积量特征对BPSK、QPSK和{1／4一QPSK、8PSK}信号进行识别，然后再利用信号差分的四阶和八阶累积量特征对1/4-QPSK、8PSK信号进行识别。从理论上分析了的该算法的有效性，并通过计算机仿真验证了算法具有良好的性能。(A recognition algorithm based on differential high-order cumulant is proposed for the modulation recognition problems of BPSK, QPSK, 1/4-QPSK and 8PSK, which are commonly used in current communication signals. The algorithm is divided into two levels for modulation recognition. Firstly, BPSK, QPSK and {1/4-QPSK, 8PSK} signals are identified by using the fourth-order cumulant characteristics of signals, and then 1/4-QPSK and 8PSK signals are identified by using the fourth-order cumulant and eighth-order cumulant characteristics of signal difference. The validity of the algorithm is analyzed theoretically, and the good performance of the algorithm is verified by computer simulation.)