untitledPM

Stop-and-wait ARQ is a method used in telecommunications to send information between two connected devices. It ensures that information is not lost due to dropped packets and that packets are received in the correct order. It is the simplest kind of automatic repeat-request (ARQ) method. A stop-and-wait ARQ sender sends one frame at a time it is a special case of the general sliding window protocol with both transmit and receive window sizes equal to 1. After sending each frame, the sender doesn t send any further frames until it receives an acknowledgement (ACK) signal. After receiving a good frame, the receiver sends an ACK. If the ACK does not reach the sender before a certain time, known as the timeout, the sender sends the same frame again.

说明：  modeling of induction motor

eQUAL AREA CRITERION

非常实用的普朗克公式的计算代码,使用MATLAB编写(Planck equation very practical computing code，Using MATLAB prepared)

模式识别中常用的算法，有感知机算法，支撑矢量机算法和LS算法，并附有实验报告，源程序！(Commonly used pattern recognition algorithms, has perceptron algorithm, support vector machine algorithm and the LS algorithm, along with lab reports, source code!)

Introduction to the Issue on Cooperative Communication and Signal Processing in Cognitive Radio Systems

MATLAB信号系统教程含源码测试通过 复制代码到.m文件即可 (MATLAB Signal System tutorials with source code to the test by copying. M files can)

光纤光栅包层不同时，纤芯基模折射率与波长之间的关系(the relationship between the refractive index of the core fundamental mode fiber grating wavelength between cladding)

介绍压缩采样技术的优点，并介绍其在雷达回波信号处理中的应用情况(Describes the advantages of compression sampling techniques, and describes its application in radar echo signal processing)

概率神经网络机械故障诊断matlab程序 通过振动信号预判机械故障(Diesel Engine Fault Diagnosis)