小学期电信16-1秦毫

sdhci-pltfm.c Support for SDHCI platform devices.

485的msp430通讯,包括主机和从机的程序.多机通讯,例子是三个弹片机,可以扩展多个,硬件终端电阻要求120,(485 Controller communications, including mainframe and from the plane procedures. Multi-machine communication, shrapnel example is the three aircraft that can extend multiple hardware requirements terminal resistor 120,)

该程序为数码管静态显示程序。 每按一次 独立按键 中的 T0，数码管的值便会加一(The procedure for the digital static display program. Each time you press the button in the Independent, the value of the digital tube will add a T0)

xe166系列的CCU6模块、ADC模块、PEC模块结合使用的例程,是英飞凌单片机培训的好资料(xe166 series CCU6 module, ADC module, PEC modules used in conjunction with routine, is a good training materials Infineon microcontroller)

ds1302例程，本例程来源网络，本人验证通过，特此上传供大家学习交流(ds1302 routine, the routine source network, I verify hereby uploaded for everyone to learn exchange)

基于MLX90614的公共场所体温快速检测器的设计(......delay.asm ......hex2asc.asm ......Init.asm ......main.asm ......main.COD ......main.err ......main.HEX)

说明：  蓝桥杯CT107D矩阵键盘的源代码测试使用供学习和参考(Blue Bridge Cup Matrix Keyboard)

说明：  设计一个正弦信号发生器，使用凌阳公司的16位单片机SPCE061A作为中央控制器，结合DDS芯片AD9850，产生0～15MHz频率可调的正弦信号,正弦信号频率设定值可断电保存；使用宽频放大技术，在50Ω负载电阻上使1K～10MHz范围内的正弦信号输出电压幅度VP-P=6V±1V；产生载波频率可设定的FM和AM信号；调制信号为1KHz的正弦波，调制信号的产生采用DDS技术，由CPLD和Flash ROM加上DAC进行直接数字合成；二进制基带序列码由CPLD产生，在100KHz固定载波频率下进行数字键控，产生ASK，PSK信号。(Design of a sinusoidal signal generator, the use of Sunplus 16-bit MCU SPCE061A as the central controller, combined with DDS chip AD9850, have adjustable frequencies 0 ~ 15MHz sinusoidal signal, sinusoidal signal frequency settings can be stored power using broadband amplification, in a 50Ω load resistor to 1K ~ 10MHz sinusoidal signal within the output voltage amplitude VP-P = 6V ± 1V generating the carrier frequency of the FM and AM can be set signal 1KHz sine wave modulation signal, modulated signal generation using DDS technology, coupled by the CPLD and Flash ROM DAC for direct digital synthesis binary baseband sequence code generated by the CPLD in a fixed carrier frequency 100KHz digital keying, resulting in ASK, PSK signals.)

说明：  can 双机调试通过，stm32f105 MCU 使用的hawerlib，可以使用usb转can设备监控数据的发送。(Can dual computer debugging passed, STM32F105 MCU USES the Hawerlib, you can use USB can device to monitor the transmission of data.)

该程序是为大家提供简单的AD程序,实现AD转换(This program is to provide you with a simple AD program to achieve AD conversion.)