tem_huli_MAX_soon

新唐NUC1XX系列CONTEX-M0 CPU BSP文件。(New Tang NUC1XX series CONTEX-M0 CPU BSP file.)

带接收和发送协议处理的串口调试工具，可只接收并显示自定义关键字的串口数据，非常好用，带这种功能的可用的此类软件不多，值得收藏。(ComFilter,can receive and display your expired information from COM.)

说明：  用89C51的P1口做输出口，接八只发光二极管；P3口接按钮开关，作为控制信号的输入(89C51 to do with the P1 port output, take eight light-emitting diodes P3 port access button switch, as a control signal input)

利用MSP430单片机实现5分钟倒计时。用Timer_A实现1s定时，4位共阳型数码管显示时间，显示格式为：“x-xx”，分别代表“分”、“十秒”和“秒”。每隔1s，倒计时器的时间减1，倒计时从4分59秒开始计时，至0分0秒结束，停止计时。(MSP430 microcontroller is used to realize 5 minute countdown. Timer_A is used to realize 1s timing and 4-bit common-sun digital tube display time. The display format is "x-x x", representing "minutes", "ten seconds" and "seconds" respectively. Every 1s, the countdown time is reduced by 1. The countdown time starts at 4:59 seconds and ends at 0:0 seconds.)

说明：  关于单片机的芯片手册，希望对大家有用，尤其是初次接触这款芯片的(About the chip Manual of single chip computer, I hope it will be useful to you all.)

多点温度循环测量可以实现多个点温度循环检测并显示(Multi-point temperature measurement cycle can implement multiple point temperature loop detection and display)

基于rc531读写芯片的读写源程序，读取ID卡的ID号(rc531 typeB)

说明：  利用STM32F106RET6的串口1发送字节或数据(STM32F106 com comunication)

说明：  STM8 开发环境、最小项目工程、最小系统 二、STM8S的最小硬件系统 STM8的最小硬件系统包含下列部分： 1、电源 2、时钟管理 3、复位管理 4、调试接口(SWIM) (Development EnvironmentSmallestProjectSystem)

一调试好了，放心使用吧，很好的，保证你会满意的。(A debugging good, feel free to use, very good, guarantee that you will be satisfied.)