Project_III

说明：  AD9854DDS信号发生器stm32驱动代码(AD9854DDS Signal Generator STM32 Driver Code)

说明：  LCD1602八线制驱动实验(ICC)的proteus仿真,功能实现了还不错的(LCD1602 Driver of eight-wire (ICC) of the proteus simulation capabilities to achieve a decent)

DS18B20 1602液晶显示，51程序和仿真。

基于MAP430F149单片机的典型例题，很有帮助(Microcontroller based MAP430F149 a typical example, very helpful)

CC2530定时器3比较输出模式，解压后直接使用(CC2530 Timer 3 compare output mode directly after decompression)

硬件TCPIP协议栈芯片W5300的使用例子代码,该芯片内部通过硬件实现了TCPIP协议栈,可减少CPU运行协议栈的开销.(Hardware TCPIP protocol stack chips W5300 examples of the use of code, the chip hardware implementation of the internal adoption of the TCPIP protocol stack can reduce the CPU overhead of running the protocol stack.)

32控制的防尾随门，主要应用于银行安检防盗门(32-controlled anti-tail door)

STM32F405RGT6 的CAN1和CAN2相互通信，一个发送，一个接收，采用HAL固件库(STM32F405RGT6 of CAN1 and CAN2 communicate with each other, a sending a receiving using HAL firmware library)

基于最小冗余线阵的谱相关共轭循环MUSIC算法(MUSIC algorithm based on conjugate cyclic spectral correlation minimum redundancy linear arrays)

stm32的usart1和usart3配置为串口通信，均用中断实现串口接收。(stm32 usart1 and usart3 configured for serial communication, both with the serial port receive interrupt achieve.)