auto_and_shift

一维自组织特征映射网络对输入向量空间进行识别分类(One-dimensional self-organizing feature map network input vector space to identify categories)

truetime 的例子（I),介绍AODV，使用truetime2.0(truetime example (I))

一杯沸水冷却，圆柱体模型，底面半径0.05m，高0.1m，周围温度20度，初始水温100度 方程是四维输运方程（常数a^2=k/(c*p)，k是热传导系数0.6006焦/（米*秒*度）） 初始条件：t=0时水等于100度 边界条件：1.上下壁都是自由冷却，第三类边界条件，周围温度保持在20度（H=k/h,h取1） 2.杯壁绝热，第二类边界条件 (cup of boiling water cooling cylinder model, the bottom radius of 0.05m, 0.1m high. temperature around 20 degrees, initial temperature of 100 degrees equation is four-dimensional equations (a constant ^ 2 = k/(c* p), k is the thermal conductivity coefficient of 0.6006 Coke/(m** seconds degrees)) initial conditions : t = 0 to 100 degree water boundary conditions : 1. upper and lower walls are free cooling, the third boundary conditions, maintain the temperature around 20 degrees (H = k/h, h for 1) 2. Beibi insulation, the second boundary condition)

基于深度优先搜索的电力系统分区：根据节点连接关系确定节点的所属分区，即系统最终分成多少个区域、每个区域包含哪些节点。(Power system Partition based on deep search according to connectivity , i.e., determining the number of sections and nodes in each section.)

圆阵的方向图 切比雪夫系数加权 频域搬移(Circular array pattern coefficient weighted Chebyshev frequency domain move)

matlab编制的牛顿拉夫逊法潮流分析，以及PQ、快速PQ法。采用IEEE30 节点算例(matlab prepared Newton Raphson load flow analysis, and the PQ, fast PQ method. IEEE30 bus test cases)

基于matlab的低通有源滤波器设计wp=30hz，ws=40hz，rp=0.5，rs=40，fs=100hz. (Matlab-based low-pass active filter design wp = 30hz, ws = 40hz, rp = 0.5, rs = 40, fs = 100hz.)

说明：  利用在 MATLAB Simulink 中的 SimMechanics 工具箱，在 Matlab 中搭建了机器人的机构模型，结合运动学数学模型，实现的机器人的运动模拟实验，并且通过末端执行器输入运动参数与输出运动参数的对比，验证了所建立的运动学模型的正确性。最后根据机构的实际限制条件，限制了两个主动臂的最大转动角度，结合正向运动学模型，得到了整个机器人末端执行器的极限运动位置坐标以及整个运动空间(Using the SimMechanics toolbox in MATLAB Simulink, the mechanism model of the robot is built in MATLAB. Combined with the kinematics mathematical model, the motion simulation experiment of the robot is realized. The correctness of the kinematics model is verified by comparing the input and output motion parameters of the end actuator. Finally, according to the actual constraints of the mechanism, the maximum rotation angle of the two active arms is limited. Combined with the forward kinematics model, the limit motion position coordinates and the whole motion space of the end effector of the whole robot are obtained)

按照A13律编码对一个离散序列对信号进行编码，通信原理(encode by A13-law)

说明：  五点差分求解椭圆边值问题，简单明了，运行快捷，好用(five points)