DFIG_LVRT

风光互补发电系统的知识，最大功率跟踪控制方法的介绍和研究(the content on wind and solar hybrid power generation system and the introduce about the maximum power point tracking)

自己搭的变压器的差动保护模型，对理解变压器的差动保护很有帮助(Model Transformer differential protection of their own ride, very helpful in understanding the transformer differential protection)

wind tubine modeling

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

没有用，随便上传的，一会说必然会把握科技和室内的(An all-DC offshore wind farm with series-connected turbines)

说明：  基于PSCAD的IEEE39节点测试系统，可实现电磁暂态仿真、机电暂态仿真以及小信号稳定性仿真分析等。通过E-TRAN将PSS/E数据转换为PSCAD模型，模型包含有E-TRAN的元件库等。(IEEE New England 39-bus test system based on PSCAD/EMTDC. The model can be used in electromagnetic transient simulations, electromechanical transient simulations, and small-signal stability simulations. The model is developed by using E-TRAN to transform PSS/E data to PSCAD/EMTDC model.)

8MPa 下 CO2/H2O质量比96 /4 的物性参数 适用于东芝超临界二氧化碳循环工质(8MPa under the CO2/H2O mass ratio of 96 /4 of the physical parameters for Toshiba supercritical carbon dioxide circulating fluid)

PSCAD的研究次同步振荡的程序 采用第一标准测试模型(Research PSCAD SSO standard procedures for the use of the first test model)

电信报表管理系统（完整版） 绝对值得下载的学习资料(report system)

matlab编的电力系统电压稳定分析程序，可以改进学习(compiled matlab power system voltage stability analysis program, can improve the learning)