Reactive-Power-Optimization

说明：  江苏645规约重合闸断路器控制器 模拟主站通讯(Jiangsu 645 Protocol Simulated Main Station)

IEC101-104 电力规约通讯实现及测试软件，VC2003下编译运行通过。支持串口以太网(IEC101-104 power protocol communication and testing software, VC2003 compiler run through. Support serial port Ethernet)

说明：  本模型为单项你变模型，将直流电逆变成方波，分别采用四个脉冲发生器控制四个晶闸管，经滤波后得到输出结果。(This model is a single variable model, which transforms the direct current into square wave, uses four pulse generators to control four thyristors, and gets the output result after filtering.)

一个在1毫秒中断中查询的B码接收,解码程序(IRIG B CODE recieve and decode .)

微电网，6节点的电网数据，包括风力，负荷，发电机输出功率，节点图等信息，可参考(Microgrid, 6-node grid data, including wind power, load, generator output power, node diagram and other information, can be referred to.)

atp是电力系统暂态仿真软件，在atp仿真软件上建立了IEEE三机九节点的仿真模型，并得到了潮流及稳定的仿真结果(atp is the power system transient simulation software, simulation software in the atp built on the IEEE three-machine nine nodes in the simulation model, and has been the trend and stability of simulation results)

水库调度 单库POA，以乌江梯级水库群中单库东风为例(The reservoir scheduling single library POA)

可用于如单相接地故障的仿真研究，观察考虑电弧影响的波形(It can be used in the simulation research of single-phase grounding fault, and observe the influence of arc)

蒸发冷凝的udf，，包括传热传质，对应于水(Evaporative condensation of UDF, including heat and mass transfer, corresponds to water)

说明：  基于bpa的IEEE118节点算例,包含全部发电机、线路、负荷、变压器等(An IEEE118-node example based on BPA)