chushihua

4QAM(QPSK)的调制解调以及计算误码率，最后将结果输出至表格。适合新手参考(The modulation and demodulation of 4QAM (QPSK) and the calculation of bit error rate, and finally output the result to the form. Suitable for novice)

为了对空间辐射源进行精确定位" 建立了基于任意阵列对多目标源进行二维DOA估计的数学模型。将 MUSIC算法推广到三维空间阵列可以对辐射源进行二维高精度测向,但由于其需要估计接收数据的协方差矩阵和进行特征分解, 因而其计算量较大。利用多级维纳滤波器的前向递推获得信号子空间和噪声子空间，不需要估计协方差矩阵和对其进行特征分解，从而降低了MUSIC算法的计算量。将文中的方法应用于任意阵列的二维DOA估计中进行计算机仿真和实际侧向系统性能验证,实验结果均表明该方法达到了MUSIC算法的性能,但与常规MUSIC算法相比降低了计算量.( In order to space radiation source for precise positioning" based on arbitrary array to multiple target source 2D DOA estimation model. The MUSIC algorithm is extended to three-dimensional space to two-dimensional array of radiation source for high precision direction finding, but due to the need to estimate the covariance matrix and eigenvalue decomposition, and the large amount of calculation. Use of multistage Wiener filter forward recursion received signal and noise subspace, does not need to estimate the covariance matrix and the eigenvalue decomposition, which reduces the computation of MUSIC algorithm. This method is applied to an arbitrary array DOA estimation for computer simulation and actual lateral system performance verification, the experimental results show that this method achieves the performance of MUSIC algorithm, but with the conventional MUSIC algorithm reduces the calculation amount.)

Smoothing Filter-based Intensity Modulation a spectral preserve

PEGSIS协议仿真 包含很多东西 通讯协议仿真 可用于对比 MATKLAB(PEGASIS Protocol Simulation)

A panel with test run counters.

OFDM系统包括OFDM系统的调制解调，IFFT及FFT变换，保护间隔的加入对系统性能的改善，以及多径干扰、高速移动对系统误码率的影响。(The OFDM system includes modulation and demodulation of the OFDM system, IFFT and FFT transformation, the improvement of the protection interval to the system performance, and the influence of multipath interference and high-speed mobile on the system BER.)

说明：  读取SHT20的数据发送到主控STM32F103vet6(Read data from SHT20 and send it to master STM32F103vet6)

QAM高阶调制 恒模盲均衡算法 CMA Equalization Algorithm(QAM CMA Equalization Algorithm)

说明：  5. 在三条径的瑞利信道中，对于直接序列扩频： (1) 请设计DS-CDMA一种具体的码分导引辅助的信道估计方法，接收机分别采用等均益合并、最大比合并。用Simulink进行仿真，画出比特信噪比与信道估计均方误差的关系曲线和比特信噪比与误码率的关系曲线。 (2) 设频率已经同步，请设计DS-CDMA一种具体的单停顿滑动相关时间同步方法，用Simulink进行仿真，画出比特信噪比与捕获概率的关系曲线。 (3) 设时间已经同步，请设计DS-CDMA一种具体的频率同步方法，用Simulink进行仿真，画出比特信噪比与频率同步误差的关系曲线。(5. In three-path Rayleigh channel, for direct sequence spread spectrum: (1) please design a specific code division navigation aided channel estimation method for ds-cdma, and adopt equal-beneficial combination and maximum ratio combination for receivers respectively.Simulink is used to simulate and draw the relationship curve between bit SNR and channel estimation mean square error and the relationship curve between bit SNR and bit error rate. (2) assuming that the frequency has been synchronized, please design a specific single-stop sliding correlation time synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and the acquisition probability curve. (3) if the time has been synchronized, please design a specific frequency synchronization method ds-cdma, Simulink simulation, draw the relationship between the bit SNR and frequency synchronization error curve.)

描述了智能天线在无线通信环境下的各种应用。(Describes a smart antenna in a wireless communication environment, a variety of applications.)