sync_exciter_governor1

在PSCAD环境下，采用双闭环控制的正弦脉宽调制整流器，直流侧控制效果较好。(In the PSCAD environment, using sinusoidal PWM rectifier dual closed loop control of DC side, better control effect.)

DDA方法的绘制直线 圆的绘制 曲线的绘制等(tu xing xue)

三维光子晶体的带系和结构模拟程序，用matlab编写，很好用的。(Three-dimensional photonic crystals with line and structure simulation program, using matlab to prepare, very good use.)

自己用PSCAD搭建的三相MMC带均压电路，每相采用了八个子模块(PSCAD build their own three-phase with the MMC with both voltage circuit, each phase using the eight sub-modules)

VB编写的画图板，使用方便可以帮助代码学习。。(VB prepared the drawing board, easy to use can help the code to learn. .)

又来了~~继上次之后的又一重磅出击，本程序也是图形填充(Here we go again ~ ~ Following the last after another heavy attack, the process is filled with graphics)

输入类内、类间海明距离矩阵，绘制ROC曲线，求等错误率，原理见：http://blog.csdn.net/yanzi1225627/article/details/8915032(Input class, the class Hamming distance matrix, the ROC curve, find the error rate, the principle see: http://blog.csdn.net/yanzi1225627/article/details/8915032)

主要演示Python画曲线的程序，没有太大的用处，只是为了能够下载程序(The main demonstration of Python drawing curve program, not too much use, just to download the program)

这是风机在并入无限大电网的PSCAD仿真模型，对于研究风机并网特性有很好的效果(This is the fan in the power grid PSCAD incorporated infinite simulation model for the study of fan and network characteristics have a good effect)

这是国外的同行编写的画图板程序，感觉比陈建春的要好些，说实话研究了半天，发现国内的cad水平低不是因为国内的人笨，主要是国外的cad技术不能很快的传递到国人手中，总是参考陈建华等水平有限，工程水平差的书籍造成整体水平低，书中没有详细的流程图，和软件设计思路，而且代码错误连篇。(This is the foreign counterparts of the drawing board to prepare procedures, CHEN Jian-chun than feeling the need to better tell the truth for a long time study and found that low levels of domestic cad because people are not stupid, mainly abroad cad technology should not quickly delivered to the the hands of the people always refer to Chen Jianhua, such as the limited level, engineering level difference caused by the overall level of books low, the lack of a detailed flow chart of the book, and software design, and code errors pack.)