scatterbar3

matlab图形逻辑处理程序，好程序共同分享。(matlab graphical logic handler, a good program to share.)

这是国外的同行编写的画图板程序，感觉比陈建春的要好些，说实话研究了半天，发现国内的cad水平低不是因为国内的人笨，主要是国外的cad技术不能很快的传递到国人手中，总是参考陈建华等水平有限，工程水平差的书籍造成整体水平低，书中没有详细的流程图，和软件设计思路，而且代码错误连篇。(This is the foreign counterparts of the drawing board to prepare procedures, CHEN Jian-chun than feeling the need to better tell the truth for a long time study and found that low levels of domestic cad because people are not stupid, mainly abroad cad technology should not quickly delivered to the the hands of the people always refer to Chen Jianhua, such as the limited level, engineering level difference caused by the overall level of books low, the lack of a detailed flow chart of the book, and software design, and code errors pack.)

本人主要学习研究synopsis公司的Sentaurus TCAD半导体工艺软件的使用,本程序是实现光电二极管的建模脚本(I mainly study the synopsis of Sentaurus TCAD semiconductor process software, the use of this procedure is to realize the photodiode modeling scripts)

绘图板软件，实现了文件打开，矢量保存，各种线和图形的绘画，颜色的更换。(it is a paint pad,you can use it to change your color,your paint,and can save yours.)

初学者常用的matlab绘图代码及讲解课件(Matlab drawing codes and instructional courseware commonly used by beginners)

基于PSCAD的UPFC模型，采用前馈解耦策略，有功无功基本独立控制，波形较好(Unified Power Flow Control Model based on PSCAD)

从图像中提取曲线，并检测出曲线中的峰值。支持多峰值检测。(Curves extracted from the image, and detect the peak of the curve. Support multi-peak detection.)

这是在MATLAB-2008a环境下编写的NURBS曲面生成程序，可以通过调整控制顶点和各个顶点的权重来调整曲面的形状。(This is a MATLAB-2008a environment, prepared by the NURBS surface generation program, you can adjust the control points and weights of all vertices to adjust the surface shape.)

Manejo de Imagenes usando haarcascade en QT+opencv

自己在PSCAD中搭建的PLL，用的是分立元件搭建的，有助于自己学习以及编程实现，已经与自带的PLL进行对比，验证了正确性(PSCAD built himself in the PLL, using discrete components built to help you learn and programming has been compared with the built-in PLL, verify the correctness)