homework-5-roeaHLL

两种控制方式的性能比较:模糊控制与PID控制(two ways to control the performance comparison : fuzzy control and PID control)

本程序是针对UCI图像数据集上的图像进行重构与识别的实验(This procedure is for the UCI data sets on the image to reconstruct the image and recognition of the experiment)

周长面积法（小岛法）求分形维数，编译过，非常好(xiaodao)

Matlab Simulink model. Demonstration of transciever. PSK-8 modulation. Time Division Multiplexing

Code sort the given int array in C.

说明：  升压转换器是一种DC / DC电源转换器，可将电压从其输入（源）升至其输出（负载）。在连续导通模式下（流经电感的电流永远不会降为零），升压转换器的理论传递函数为： 占空比在哪里0.5 在此示例中，转换器从250 V电源馈送RC负载，并且PWM频率设置为31 kHz。 模拟 运行仿真并观察示波器上的波形。确认负载电压（Vout）的平均值非常接近理论值：Vout = 250 /（1- 0.5）= 500V。(A boost converter is a DC/DC power converter which steps up voltage from its input (source) to its output (load). In continuous conduction mode (current through the inductor never falls to zero), the theoretical transfer function of the boost converter is: where is the duty cycle.0.5 In this example, the converter is feeding an RC load from a 250 V source and the PWM frequency is set to 31 kHz. Simulation Run the simulation and observe waveforms on Scope. Verify that the mean value of the load voltage (Vout) is very close to the theoretical value of: Vout = 250 / (1 - 0.5) = 500 V.)

matlab example to design wind turbine generator

说明：  实指数序列a=1/2 实指数序列a=1/2(Real exponential sequence a = 1/2)

三相SPWM逆变器 可以完全的观测产生的三相正弦电流(THREE LINE SIN SPWM)

关于pscad下的一个逆变器spwm仿真，有波形和参数设置，值得一看。(this is good file)