Sim_EKB_Install_2018_08_19

mma7455 的驱动程序，完美稳定版。想做三轴加速的传感器的可以看看，stm32版。(mma7455 driver, perfectly stable version. I want to do three-axis acceleration sensor can see, stm32 version.)

Complete codec LDPC code, Synthetic Aperture Radar (SAR) imaging simulation target, Analog data analysis processing.

6U CompactPCI PCB 模板，使用工具为Altium Designed 9(PCB template of 6U CompactPCI with Altium Designed 9)

光立方源程序代码，经本人使用，确定为可用程序，有详细注解(Light cube source program code, after I use, determine the available procedures, a detailed explanation)

msp430控制DS18b20温度采集系统，并经过LED显示(msp430 ds18b20 led)

串口通讯232，接受上位机发出的指令来控制一个继电器的开关状态(Serial communication 232, to accept the instructions issued by the host computer to control a relay switch state)

msp 430 使用sd卡制作的mp3播放器。spi数据传输。(mp3 player with msp430f149 and sd card for memory.)

本文设计了基于加速度传感器的计步器，并通过仿真以及实际调试得到了相应的结果的记录。本实验首先通过加速度传感器检测目标物体的运动，产生脉冲，将脉冲放大后经过施密特触发器整型为方波，并给出了方波的调试电路图。然后编写程序，利用D触发器检测方波的上升沿，当上升沿到来时，计数，并对十位、个位分别编码，然后由使能信号交替控制数码管输出结果。本文给出了仿真以及调试的程序、结果。(This article is designed pedometer-based acceleration sensor and the corresponding results recorded by simulation and debugging. The experiments by first acceleration sensor detects the movement of the target object, generates a pulse, the pulse amplification is a square wave after the Schmitt trigger integer, and gives the the debug circuit diagram of a square wave. Then write procedures, the use of the rising edge of the detection of the square wave of the D flip-flop, when the rising edge, the count, and ten bits are encoded, and then alternately by the enable signal output of the digital control. In this paper, a simulation and debugging procedures, results.)

c语言开发单片机 控制跑马灯的亮度的变化 按键控制亮度增减(C develop SCM Control the brightness of the scrolling the change of control buttons increase or decrease brightness)

基于stm32vbt6的systick精确延时控制流水灯的程序(Based stm32vbt6 the systick precise delay program to control water light)