超级终端_中文_Unicode

用VS2010编写的串口调试助手，很有用(Written with VS2010 serial debugging assistant, very useful)

说明：  数控程序传输，主要是三个程序，KND及GSK990m传输软件，Sercom，hmcadcam_Dnc(NC program transmission, there are three main procedures GSK990m KND and transmission software, Sercom, hmcadcam_Dnc)

OFDM通信系统抗多径衰落干扰研究,顺便求OFDM系统中关于频谱偏移的估计与补偿的,(The research on the anti-multipath fading interference in OFDM communication system, and the estimation and compensation of spectrum offset in OFDM system,)

说明：  串口通信程序，带有GUI界面 串口通信程序，带有GUI界面 matlab(serial communication serial communicationserial communication matlab)

利用LABVIEW开发环境，实现GPIB串口通讯(无)

DOS 下使用串口传输文件。并可工作在超级终端模式。(DOS, use the serial port to transfer files. And work in HyperTerminal mode.)

云台控制的C++详细源码，二次开发可以直接用。(The PTZ control C++ detailed source, secondary development can be directly used.)

实用28335设计的串口通信，可以接收远距离的信号，对于初学者很有帮助(28335 Serial Communications Utility designed to receive distant signals, useful for beginners)

希捷硬盘维修软件，通过COM口与硬盘通信，进行ROM和固件的读写，开启工厂自校准进行固件和坏道的自动修复。(Seagate hard disk repair software, communicate with hard drive, through the COM ROM and firmware, speaking, reading and writing, open the factory since the calibration for the firmware and bad auto repair.)

说明：  uart的vhdl实现代码 分模块设计和状态机设计 不错的，用它没错(UART achieve the VHDL code modular design and state machine design good, the right to use it)