带ID的lpc2368 CAN通信

给出了基于MFC的can232接口的调试程序(MFC-can232 given based debugger interface)

标准串口和模拟串口4位164动态数码管显示程序 1.CPU ：89C51 晶振2MHz 2.在proteus上仿真通过 3. 测试时将部分语句屏蔽 (Standard serial and analog serial 4 164 dynamic digital tube display program 1.CPU: 89C51 crystal 2MHz 2. The proteus simulation through 3 will be part of the statement shield test)

说明：  数控程序传输，主要是三个程序，KND及GSK990m传输软件，Sercom，hmcadcam_Dnc(NC program transmission, there are three main procedures GSK990m KND and transmission software, Sercom, hmcadcam_Dnc)

labwindows 串口编程 简单易懂 做虚拟仪器的同学可以看看 或许对你有用(programming straightforward labwindows serial do virtual instrument students can take a look at perhaps useful to you)

modbusRTU Communications with RS485

串口检查源码，VC++工程项目，经典串口通信工具(failed to translate)

使用MSCOMM控件，实现两台电脑通过串口进行通信的功能。(Use MSCOMM control, to achieve two computers to communicate through the serial port function.)

说明：  串口通信高级编程提供了一个能够进行串口通信的类，能够方便地进行各种数据通信。 由于本程序设计到硬件编程，因此，如果读者的串口通信设备 没有连接好，可能会有问题 (Serial communication provides a high-level programming to carry out the type of serial communication, the ability to easily carry out a variety of data communications. Since the hardware design to programming, so if the reader' s serial communications equipment is not connected well, there may be some problems)

说明：  BCB串口通讯源码示例程序。利用winapi函数，而非控件。(BCB examples of serial communication program source. Use WINAPI function, rather than control.)

串口调试：这还是个初步的！如果你有兴趣还可以自己再改！如果还有更好的请联系我(serial debugger : This is still preliminary. If you are interested in then they can change! If there is a better contact I)