BLDC-control-of-DSP

这是基于开发板LPC1114的源码程序，是用C语言编写，关于液晶显示屏的配置和实现同时它也是一个完整的模板，可以在此基础上添加其他程序用于开发板的学习，是一个完整的模板，可直接使用。(This is based on the development board LPC1114 source code program, is written in C language, on the LCD display configuration and implementation at the same time it is a complete template, you can add other programs on this basis for the development board learning, is a complete template, can be used directly.)

基于单片机的DDS信号发生器，可产生正弦曲线和三角波形(DDS signal generator based on MCU, can generate sinusoidal and triangular waveform)

基于最小冗余线阵的谱相关共轭循环MUSIC算法(MUSIC algorithm based on conjugate cyclic spectral correlation minimum redundancy linear arrays)

STM32 使用ADC4个通道检测电压值，DMA依次输出。(ADC4 STM32 channel DMA output.)

C51单片机例程，通过红外线用按键使数码管显示键值(C51 microcontroller routines, through infrared button digital tube display key)

51单片机led流水灯例程，利用查表法显示8个led流水灯效果(51 single led light water routine, use a lookup table to display 8 led light water effects)

16位瑞萨单片机RL78G13 SPI程序 现在网上瑞萨资料基本没有(16 Renesas MCU RL78G13 SPI program online now basically no Renesas data)

实现AVR单片机的串行通信(接受与发送数据）的C语言源代码(Achieve AVR microcontroller serial communication (accept and send data) C language source code)

开发一个基于液位传感器的液位监控系统，可测量并显示液位高度。设定最高液位和最低液位，当液位高于最高液位或低于最低液位时发出报警信号，提醒工作人员液位信息。(A liquid level monitoring system based on liquid level sensor is developed to measure and display the height of liquid level. Set the highest liquid level and minimum liquid level. When the liquid level is higher than the highest liquid level or lower than the lowest liquid level, the alarm signal is sent out to alert the staff level information.)

spwm逆变器供电的无刷反馈电机调速系统的m文件编的算法()