-
mppt控制仿真
说明: 此模型是基于matlab/simulink下的最大功率跟踪控制,能有效地追踪最大功率(This model is based on the maximum power tracking control under matlab/simulink, and can effectively track the maximum power.)
- 2019-03-22 20:28:54下载
- 积分:1
-
数据记录读取
利用labview程序实现所记录数据的自动读取(Automatic recording of recorded data using LabVIEW program)
- 2020-08-06 20:38:31下载
- 积分:1
-
The-average-value-filter
利用labview语言进行平均值的滤波分析,并得出分析的结果(use labview to achieve the average value filter)
- 2021-04-16 19:18:53下载
- 积分:1
-
SNAKE
LABVIEW贪吃蛇案例程序,希望能有用!(Snake Case LABVIEW program, hoping to be useful!)
- 2014-01-05 18:59:36下载
- 积分:1
-
通过串口采集下位机信息 smart
本程序是基于LABWINDOWS/CVI 的,主要是通过串口采集下位机信息,然后显示状态信息并通过串口发送命令字节。(The program is based on LABWINDOWS/CVI.It get message from RS232and display status,then send command by RS232.)
- 2011-11-28 21:08:44下载
- 积分:1
-
Labview实现8路信号同步采集源码
可以采集多路ADC值,真的很好用,用labview编的(Can collect multi-channel ADC value, really good use, compiled by LabVIEW)
- 2021-04-17 21:08:52下载
- 积分:1
-
TX_single signal
关于labview的USRP编写的扫频信号,观察其时域和频域波形(On the sweep signal written by USRP of labview, the waveforms in time domain and frequency domain are observed.)
- 2018-12-20 20:23:51下载
- 积分:1
-
Peak-and-Valley-Detection
labview环境下实现emd分解,而且是无密码的版本(labview environment to achieve emd decomposition , and is the version without a password
)
- 2013-09-23 15:48:41下载
- 积分:1
-
hanshuxinhaofashengqi
1.采用Labview设计一虚拟函数信号发生器, 通过数据采集卡输出波形信号,调节信号的相关参数,可观察示波器上波形的变化情况。
⑴ 以NI MyDAQ数据采集卡作为输出接口;
⑵ 数据采集卡输出多种信号,至少完成三种波形:正弦波、三角波、方波(可调占空比)的输出,同时前面板上显示各输出波形;
⑶ 频率、幅值、初相位、直流偏移量和方波的占空比(0~100 )等参数可以通过前面板控件调节。
⑷ 前面板可显示输出波形。(1. Labview design using a virtual function signal generator, data acquisition card output waveform signal, adjust the relevant parameters of the signal can be observed on an oscilloscope waveform changes.
⑴ with NI MyDAQ data acquisition card as output interface
⑵ data acquisition card output a variety of signals, to complete at least three waveforms: sine wave output, triangle wave, square wave (adjustable duty cycle), while each of the output waveform is displayed on the front panel
⑶ frequency, amplitude, initial phase, the DC offset and duty cycle square wave (0 to 100 ) and other parameters via the front panel controls to adjust.
⑷ output waveform can be displayed on the front panel.)
- 2015-04-25 18:26:52下载
- 积分:1
-
Continuous-Sound-Input
labview报表工具包及实例,方便labview程序及界面的打印、输出报告等。(labview toolkits and examples of statements, convenient interface labview program and print output reports.)
- 2014-02-16 10:57:00下载
- 积分:1