flunet

主要介绍高光谱图像技术在食品与农业中的应用，包括原理及具体的例子，是高光谱技术研究的好书。(Introduces hyperspectral imaging technology in food and agriculture applications, including principles and specific examples, books hyperspectral technology research.)

ABAQUS结构工程实例分析，内含子程序二次开发教程，可开发材料本构模型(ABAQUS Structural Engineering Example Analysis, Subprogram Secondary Development Course, Developable Material Constitutive Model)

基于PSCAD4.5的双馈感应式风力发电系统仿真，矢量控制(Simulation of doubly fed induction wind power generation system based on PSCAD4.5 and vector control)

轴承故障诊断，自己编写的基础EMD分解程序，实测很好用。(Bearing fault diagnosis, self-compiled basic EMD decomposition program, the actual measurement is very useful.)

采用相场方法，计算纯物质枝晶生长，标记为相场模型C。(Dendrite growth of pure substance was calculated by phase field method, marked as phase field model C.)

Mie散射相函数MATLAB源程序，求mie散射系数an、bn及散射角等(MATLAB Functions for Mie Scattering and Absorptio)

说明：  abaqus中vumat下铝的fortran本构，二次开发，只适用于初学者，非常简单的那种(FORTRAN constitutive model, secondary development, elementary study)

这是matlab的代码，用于lfmsk雷达波形和比相法测角的仿真代码，望有用的人自取(this is used to simulate the lfmsk and angle figuring)

说明：  三极管放大实验电路，包括固定偏置/分压偏置，需要根据一些参数确定所选用的电阻值，使得三极管工作在放大状态。本程序将电路设计设计成GUI模式，界面上只需要输入电路设计所需参数，根据相关理论推导，给出相关参数的理论值（放大倍数、输入电阻、输出电阻等），指导实验电路搭建。软件搭建在matlab gui上，方便使用 若干参数说明 beta：三极管放大倍数 Ic：集电极电流 Uce：期望CE间电压 UeCof：Re电阻上点电压与Ucc电压比值，一般0.1-0.2 IbCof：Ib上电流与流过Rb1、Rb2电流的比值，一般0.1 ShuntCe：是否有旁路电容(The experiment circuit of triode amplification, including fixed bias / partial voltage bias, needs to determine the selected resistance value according to some parameters to make the triode work in the amplification state. In this program, the circuit design is designed into GUI mode. Only the parameters needed for circuit design are needed on the interface. According to the relevant theoretical derivation, the theoretical values of the relevant parameters (magnification, input resistance, output resistance, etc.) are given to guide the construction of experimental circuit. The software is built on Matlab GUI, easy to use)

说明：  将CATIA数据里面的2层和3层焊点，批量生成point点。(Two and three layers of solder joints in CATIA data are generated in batches.)