CANopen_master

安卓上的蓝牙串口助手，包含源代码，可以和单片夹等其他的设备相连。(Bluetooth serial port on Andrews assistant, including source code, and other devices can be connected to single folders.)

说明：  LIN 2.1总线通信协议标准，比原来的2.0标准有很大不同，研究LIN必备。(LIN 2.1 bus communication protocol standards, than the original 2.0 standard is quite different, research LIN essential.)

各种信道估计算法,用matlab做的 很有用的,大家可()

1 两路编码器输入通道 2 采用专用编码器计数芯片完成计数工作 3 与上位机串口通讯(1 two-way encoder input channel 2 using a dedicated encoder chip count as counting work 3 serial communication with the host computer)

说明：  串口通讯实验： 本实验得到的结果为，打开超级终端，设置波特率为115200，数据流控制位为无。运行系统，就会显示“UART & Interrupt Experiment,Please Input from the keyboard”，我们就可以通过写串口操作。 在flash调试时，需要修改RO BASE为0x00000000，其他不用修改，重新编译下载就可运行。 注意：由于系统产生中断，程序计数器就会跳到0x18处执行中断服务子程序，所以不能在SDRAM调试。 (Serial communication experiment: the results of this experiment, open HyperTerminal, set the baud rate to 115200, data flow control bit is not. Operating system, it will display &quot UART &amp Interrupt Experiment, Please Input from the keyboard&quot , we can write the serial port operation. Debug in flash, you need to modify the RO BASE is 0x00000000, the other not modify, recompile download can run. Note: Due to system interrupt, the program counter will jump to 0x18 Department execute the interrupt service routine, it can not debug the SDRAM.)

Visual c++实践与提高——串口通信与工程应用篇10源代码(Visual c++ practice and improve- serial communication and project source code (Application) 10)

使用stm32的串口实现fifo队列缓冲读写数据，值得新手学习((Using STM32 serial port to realize FIFO queue buffer read and write data, it is worth learning by novice.))

高速同步串口芯片PEB20534的驱动程序(high-speed synchronous serial port chip PEB20534 driver)

云雀（SLARK)AHRS姿态解码程序,将从串口获得的数据包解码成三个姿态角(The decoding of slark AHRS from URAT port!)

串口程序，有定时发送，包含了一般的串口功能(Serial procedures, time sent, including the general function of serial)