SerialPort

说明：  串口调试小程序，对初学者很有帮助，请放心下载。(Serial debugging program is very helpful for beginners, please feel free to download.)

双串口通信,实现单片机串口的接收数据，和想单片机发送数据的功能，希望对大家有所帮助。(Dual serial communication, the realization of MCU serial port data reception, and want MCU data transmission function, hope to help you.)

有关labview 的串口通信，实时显示数据，并且进行后台保存，输出文件(about labview serial com interfce communication ,diaplay data timely and save it behind )

支持gsm编解码的算法库,可用于建立移动通信应用程序,()

串口之间传送数据，可发送大量数据，并实时接受数据(Serial port to send large amounts of data, and can accept data, and data transmission...)

说明：  串口通讯实验： 本实验得到的结果为，打开超级终端，设置波特率为115200，数据流控制位为无。运行系统，就会显示“UART & Interrupt Experiment,Please Input from the keyboard”，我们就可以通过写串口操作。 在flash调试时，需要修改RO BASE为0x00000000，其他不用修改，重新编译下载就可运行。 注意：由于系统产生中断，程序计数器就会跳到0x18处执行中断服务子程序，所以不能在SDRAM调试。 (Serial communication experiment: the results of this experiment, open HyperTerminal, set the baud rate to 115200, data flow control bit is not. Operating system, it will display &quot UART &amp Interrupt Experiment, Please Input from the keyboard&quot , we can write the serial port operation. Debug in flash, you need to modify the RO BASE is 0x00000000, the other not modify, recompile download can run. Note: Due to system interrupt, the program counter will jump to 0x18 Department execute the interrupt service routine, it can not debug the SDRAM.)

通过串口来通信，控制PLC，单片机各种伺服变频等实现运动。(Through serial port to communicate, control PLC, microcontroller servo frequency conversion and so on to achieve movement.)

说明：  电容感应按键，（TWO KEY）检测程序，串口通信和CRC校验。(Capacitive sensing buttons, (TWO KEY) testing procedures, serial communications, and CRC check.)

arcsight logger api

44B0 ARM7处理器的串口通信程序，包括初始化和硬件驱动。(44B0 ARM7 processor serial communication procedures, including drivers and hardware initialization.)