Robust_Optimization

基于MATLAB中的Simulink模块中的双馈风机仿真示例，在此基础上重新设定合理的风机、配网及大电网的参数，设计加入四分量叠加法的风速模型。同时设计了110KV电网电压突然下降，在风电场并网点选择不同模式下的仿真结果分析和35KV配网发生三相短路故障时的风电机组输出特性仿真(Based on the simulation example of the doubly fed fan in the Simulink module in MATLAB, the parameters of the rational fan, distribution network and large power grid are reset on this basis, and the wind speed model with four component superposition method is designed. At the same time, the sudden drop of 110KV power grid voltage, simulation results analysis in different modes of wind farm and dot selection and the simulation of the output characteristics of the wind turbine when the three-phase short circuit fault occurs in the 35KV distribution network)

试射法——射线追踪程序。 可分别做直达波，折射波，反射波。 射线正演模拟入门程序之一！！(Test method- ray-tracing procedures. Can be done direct wave, refracted wave, reflected wave. Ray is one of forward modeling procedure entry! !)

说明：  气藏物质平衡分析软件，辅助进行气藏数值模拟(Material balance analysis software of gas reservoir to assist in numerical simulation of gas reservoir)

说明：  永磁同步电机控制器程序，主控芯片为dspic30F6012A(Program of permanent magnet controller, the main control chip is dspic30F6012A)

这个程序主要用于计算电力系统的潮流，进而了解电力系统的运行状态。(This procedure used to calculate the power flow, and then understand the power system operating state.)

风机模型，自改风机模型单双馈模型pscad对微网的构成一部分，用来对事物进行控制参数优选用了好久了(Fan model, self changing fan model, single and double fed model PSCAD part of the microgrid constitute a part of the control parameters that have been selected for a long time.)

基于MATLAB/CPLEX 的机组最优组合，成功求解表格化，图示化的机组组合结果，含机组各时段启停计划、机组各时段最优出力，以及内含的各时段的直流潮流等。(Based on the MATLAB/CPLEX optimal combination of units, the results of tabular and graphical unit commitment are successfully solved, including the start-up and shutdown schedule of each unit, the optimal output of each period of the unit, and the DC power flow contained in each period.)

说明：  基于bpa的IEEE118节点算例,包含全部发电机、线路、负荷、变压器等(An IEEE118-node example based on BPA)

说明：  用于形成网络方程所用的matlab程序，大概看一下就能懂(Matlab program used to form network equation)

This is modulation of windfarm Doubly Fed Induction Generator using PSCAD.