fangfangwenzhang

关于链式STATOM星形接法的研究，通过matlab绘制了仿真电路图(study on Y-STATCOM)

配电网网损计算，前推回代算法，基于分成分区原理(Distribution network loss calculation, forward and backward substitution algorithm is divided into partitions based on the principle)

说明：  高压直流输电的下垂控制 一个好用的基本模型(FourTerminalHVDC_droop)

说明：  独立直流配电电力系统仿真 四发电机组带整流负载运行 含自建调速器(Simulation of Independent DC Distribution Power System Four Generators Running with Rectifier Load Including self-built governor)

IEC101-104 电力规约通讯实现及测试软件，VC2003下编译运行通过。支持串口以太网(IEC101-104 power protocol communication and testing software, VC2003 compiler run through. Support serial port Ethernet)

说明：  利用Blackman窗函数对工频信号进行加窗FFT后校正计算出基波和谐波的幅值、频率和初始相角。(Blackman window function using frequency signal windowed FFT is calculated after the correction of fundamental and harmonic amplitude, frequency and initial phase angle.)

三相异步电机的调速特性分析，弱磁调速，变频调速，降压调速。记得要改仿真路径！(Phase induction motor speed control characteristic analysis, weak magnetic speed, frequency control, blood pressure governor. Remember to change the path simulation!)

用PQ分解法实现潮流计算，程序已调试，打开即可用，学校课设必备(Realization of Power Flow Calculation by PQ Decomposition Method)

说明：  用牛顿法计算电力系统在级联故障下的潮流，对越限支路进行切除负荷。(Newton method is used to calculate the power flow of the power system under cascaded fault, and the load is cut off for the out of limit branch.)

已知压气机的状态参数可求解出该状态下的特性线(if the state of compressor had been knowed,the code is used to calculate the charcter line)