MCS-51单片机软件仿真器 for DOS v4.6

单片机MC9S08AW60脉宽调制 TPM1CH3 LS2亮度控制 KBI SEG控制亮度等级 。本工程为定时器输出PWM波测试工程实例通过对PWM占空比的调节,实现小灯的渐亮的功能,当占空比为100％时再从0％逐渐增加.PWM的周期一定要足够的快,否则其输出电压的波动范围很大,且测不出一个稳定的电压值,这样通过就观察不到小灯渐亮效果. 另外,在改变PWM的周期和占空比之前和之后要分别禁止和使用。(MC9S08AW60 pulse width modulation TPM1CH3 LS2 brightness control KBI SEG brightness level. This project is an example of testing the output PWM wave of the timer. By adjusting the duty ratio of the PWM, the function of the small lamp gradually brightening is realized. When the duty ratio is 100%, the period of the small lamp gradually increases from 0%. The period of the PWM must be fast enough. Otherwise, the fluctuation range of the output voltage is large and a stable voltage value can not be measured, so the effect of the gradual brightening of the small lamp can not be observed. In addition, the period of the PWM is changed. Before and after duty cycle should be prohibited and used separately.)

说明：  基于STM32F103的hc-05蓝牙串口收发程序(Hc-05 Bluetooth serial transceiver based on STM32F103)

说明：  IAR 工程，使用标准库，减少建立工程实践，IAR版本8.xxx(IAR Project use std periph)

用关联概率对认知无线电异构网络中的用户卸载技术进行定量分析(Was analyzed by the associated probability of heterogeneous networks Cognitive radio technology users to uninstall)

32 F429同时使用定时器2和4实现中断控制LED0和1闪烁(USING TIM2 AND TIM4 IN THE MEANWHILE)

一个通过USB->UART读取C8051F060的程序，实现曲线分析、放大、报表等，采用多线程。 驱动从www.silabs.com下载，要用NI的UI控件。完整版。(a USB-)

说明：  这是我在学习红外遥控接收时写的代码，可能有一点用！(This is my infrared remote control receiver in learning to write code when there may be a point to use!)

关于桌球、蝴蝶的动态效果，还有canvas的简单实现花的效果( the dynamic effect of butterfly and table tennis)

dspic33系列单片机，直流无刷电机控制程序，程序有注释，已调试修改(dspic33 series microcontroller, brushless DC motor control procedures, program notes, have been debug modification)

红外小车壁障程序，通过红外发射和接收模块传送回来的数字信号编程，使小车能够沿着黑线行走(Through infrared send back digital signal transmitting and receiving module programming, make the car can walk along the black line)