AUCFR-thesistemplate

说明：  针对数字卫星常用的 7 种通信信号调制方式(QPSK、8PSK、16QAM、32QAM、64QAM、16APSK、32APSK)，对零中心归一化瞬时幅度谱密度最大值、四次方谱、幅度、高阶累积量四种特征参数进行了分析，提出了一种联合特征参数的信号调制识别方法．(Aiming at seven communication signal modulation modes commonly used in digital satellite (QPSK, 8PSK, 16QAM, 32QAM, 64QAM, 16APSK and 32APSK), four characteristic parameters of zero-center normalized instantaneous amplitude spectral density, quadratic spectrum, amplitude and high-order cumulant are analyzed, and a signal modulation recognition method of joint characteristic parameters is proposed. Method.)

this is a paper for pcf beam splitter!

Blimpduino is a very low cost open source autonomous blimp. It consists of an Arduino-based blimp controller board with on-board infrared and ultrasonic sensors and an interface for an optional RC mode, a simple gondola with two vectoring (tilting) differential thrusters, and ground-based infrared beacon. It will be available as a commercial kit, complete with a mylar envelope, in late 2008.

TDOA algorithm presentation

This thesis presents simulation data on array operation in wideband communication systems. It is shown that array structures with closer inter-element spacing outperform structures with much larger inter-element spacing. It is also shown that circular structures outperform linear structures. This performance dierence between the classications of arrays is due largely to the circular array s ability to handle high levels of interference. Even though a diversity combining scheme (MRC) was used in the simulator, the arrays provided interference rejection capabilities due to the closely spaced antenna elements.

MICREL GIGABIT PHY KSZ9021GQ(I).pdf

thesis document used for ph.d degree

支持IEC60870-5-104: 2000 IEC104规约软件包 实现104规约主站侧链路层的功能(IEC_Master_104.lib: void Init_SockServerport(WORD port=2404) void Init_Linkpara(int t0=30,int t1=15,int t2=10,int t3=20,int k=12,int w=8) virtual void On_init_Link_process() virtual void On_init_Sock_process() virtual void On_ErrorMsg(char*msgbuf) void slave_start() void slave_close() )

在TOA测距的基础上，提出了一种三维无线传感器网络节点定位算法，并对其性能进行了分析，给出了算法的时间同步误差和定位误差。最后在现有仿真平台OMNET++的基础上构建三维仿真模块，对算法进行了仿真实现，给出了该算法的定位精度和覆盖率(This paper proposes one three-dimensional localization algorithm based on TOA distance measurement and analyzed the performance of the algorithm calculated time synchronization error and localization error. Finally it constructed three-dimensional simulation modules based on OMNET++ and implemented the algorithm educed the localization precision and coverage.)

B-IFDMA pdf document