CST-Matlab

Final Project Proposal: Design Smart Parking System Based on WSN Using Delay Efficient Distributed Data Aggregation Algorithm

这是一个学习Symbian的ListBox的好例子,我也是看学个学会的(This is a learning Symbian a good example of the ListBox, I also watch a Institute of Science)

wcdma中的下行扰码，18级移位寄存器产生GOLD码，复扰码(wcdma a downlink scrambling code, 18 shift register GOLD code, complex scrambling code)

说明：  在实际的调谐解调电路中，采用的是非相干载波解调，本振信号与发射端的载波信号存在频率偏差和相位抖动，因而解调出来的模拟I、Q基带信号是带有载波误差的信号。这样的模拟基带信号即使采用定时准确的时钟进行取样判决，得到的数字信号也不是原来发射端的调制信号，误差的积累将导致抽样判决后的误码率增大，因此数字QPSK解调电路要对载波误差进行补偿，减少非相干载波解调带来的影响。(In the actual tuning and demodulating circuit, non-coherent carrier demodulation is adopted, and the frequency deviation and phase jitter of the local oscillator signal and the carrier signal of the transmitting end are present, and thus the demodulated analog I and Q baseband signals are signals with carrier error.)

说明：  关于ofdm系统中ml检测信号的算法，供大家参考(ML detection algorithm for OFDM system)

TOA算法C代码(Keil) 一对一(TOA)

单载波系统在高斯白噪声和多径信道条件下的仿真——加入独立字导频且采用最小二乘信道估计(Single carrier system in gaussian white noise and multipath channel under the condition of the simulation to join the independent word frequency and the least square estimation channel )

使用遗传算法优化了阵列天线方向图，亲自打的代码，已验证可使用(Genetic algorithm is used to optimize the pattern of the antenna array, and the code has been verified to be available.)

本文档，分别描述了LTE上行PUSCH信道，PUCCH信道，PRACH信道的基带信号处理流程(This document describes the LTE Uplink PUSCH each channel, PUCCH channel, PRACH channel baseband signal processing)

Visual C++高级开发范例解析第二章ActiveX源码(Visual C++ Advanced Development ActiveX sample chapter source analysis)