登录
首页 » DOS » 211UPLINKnew

211UPLINKnew

于 2010-06-23 发布 文件大小:542KB
0 380
下载积分: 1 下载次数: 233

代码说明:

  本文档,分别描述了LTE上行PUSCH信道,PUCCH信道,PRACH信道的基带信号处理流程(This document describes the LTE Uplink PUSCH each channel, PUCCH channel, PRACH channel baseband signal processing)

文件列表:

211UPLINKnew.doc,2515968,2009-02-14

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 无线定位算法代码
    关于无线传感网络二维的TDOA定位算法,内容详细(TDOA, TOA and AOA localization algorithms for wireless sensor networks are detailed.)
    2018-05-22 09:01:38下载
    积分:1
  • icmpCheater
    给任意IP地址发送一个欺骗icmp包,发送方的IP地址和MAC地址可以随意填写(To deceive any IP address to send a icmp packet, the sender' s IP address and MAC address can be free to fill)
    2013-07-12 13:07:07下载
    积分:1
  • 基于MATLAB的IIR数字滤波器的设计与仿真分析_刘兴
    说明:  数字信号处理,利用matlab语言仿真,对信号进行滤波。(Digital signal processing, using MATLAB language simulation to filter the signal)
    2019-04-12 20:59:30下载
    积分:1
  • BCJR
    BCJR 算法的matlab实现,经测试无误(matlab code of BCJR, tested without errors)
    2021-01-07 16:18:53下载
    积分:1
  • Channel_BER
    Massive MIMO Research Work.
    2016-09-03 17:53:58下载
    积分:1
  • myicqsourcecode.rar
    i c q 即 时 通 信 软 件, j a v a 实 现。 很 好 的 学 习 软 件。(icq instant messaging software, java implementation. Very good learning software.)
    2009-03-13 20:49:18下载
    积分:1
  • V2V
    v2v信道建模,参数依据论文《Deep reinforcement learning based resource allocation in V2V communications》(V2V channel modelling, parameters are based on published paper Deep reinforcement learning based resource allocation in V2V communications)
    2018-10-15 10:27:03下载
    积分:1
  • LEACH-MAC-TDMA
    OPNET仿真程序。LEACH算法在传感器网络中的实现。OPNET在无线传感器网络中的实现程序还是比较少见的。(OPNET simulation program. LEACH algorithm in sensor networks. OPNET implementation of procedures in wireless sensor networks is still relatively rare.)
    2012-08-18 09:44:07下载
    积分:1
  • gsd__source
    广义球形解码源代码,包括信噪比、复杂度、以及天线数量各种参数的仿真(Generalized sphere decoder source code, including signal to noise ratio, complexity, and various parameters of the simulation the number of antennas)
    2020-10-12 14:37:32下载
    积分:1
  • MISO_Capacity
    MIMO指多输入多输出,MIMO技术大致可以分为两类:发射/接收分集和空间复用。传统的多天线被用来增加分集度从而克服信道衰落,具有相同信息的信号通过不同的路径被发送出去,在接收机端可以获得数据符号多个独立衰落的复制品,从而获得更高的接收可靠性。这种技术往往要结合多天线技术,而多天线技术在移动通信中得到了广泛的研究。(MIMO refers to Multiple Input Multiple Output, MIMO technology can be broadly classified into two categories: transmit/receive diversity and spatial multiplexing. Traditional multi-antenna was used to increase the degree of diversity to overcome channel fading, the signal with the same information through different paths have been sent in the receiver-side data symbols can be multiple independent copies of the decline, which was higher reception reliability. This technology often have to combine multi-antenna technology, and multi-antenna technology in mobile communication has been widely studied.)
    2008-06-01 20:34:32下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载