refregeration

超简单断电复原3档亮度调光程序,每次开机都是低亮，不晃眼 低亮不是使用Pwm，而是使用电阻漏一部分电流给LED，超省电，无频闪，亮度随便调 源程序是东成的(3 super simple file recovery power brightness dimming process, each boot are low-light, non-dazzling light rather than the use of low-Pwm, but part of the use of resistance leakage current to the LED, ultra-low power, no strobe, just tune brightness source procedures of the East into)

Arduino Nano板控制RF2051混频器，设置频点功能，用Aruino标准库的IO口控制(Arduino Nano board control RF2051 mixer, set the frequency function, with Aruino standard library IO port control)

STC15单片机应用角度传感器MMA7361L调试程序(STC15 SCM application debugger angle sensor MMA7361L)

说明：  一种高精度恒流源电路的设计与实现，仪器仪表(High precision constant current source circuit, instrument)

利用DS12C887时钟芯片实现时钟的LCD显示(use DS12C887 clock chip clock LCD Display)

Trajectory generation and robot programming

使用MB95F636单片机开发的直流无刷无感电机的驱动源程序,BLDC.(Use MB95F636 MCU development Brushless DC motor drive source, BLDC.)

这是一个基于单片机的LCD显示程序，驱动LCD1602,并显示两条字符。(This is a microcontroller-based LCD display, driver LCD1602, and displays the two characters.)

说明：  串口实现类似modbus通信,方便在此基础继续完善 通信协议的开发(stm8l serial port development modbus)

4463收发程序 SPI 可实现稳定收发 基于STM32F103C8T6(4463 TX RX code MCU IS STM32F103C8T6)