flycontrol

一个用S函数写成的在dq坐标系中的双馈异步电机模型。(An S function written using dq coordinate system in the doubly-fed induction motor model.)

本程序的功能是：程序复位后，数码管从0开始显示数字，直到99，然而又从0到99循环显示(control the digital led from 0 to 99,then back to 0 and repeat 0 to 99.)

信号的幅度调制和连续信号的Fourier变换(Amplitude modulation and Fourier transform continuous signals)

matlab教学ppt，总体上概括了matlab的各种功能。(matlab teaching ppt, in general outlines the various functions of matlab.)

如何利用遗传算法工具箱函数编写求解实际优化问题的MATLAB程序(how to use genetic algorithm toolbox function optimization prepared to solve practical problems MATLAB)

用matlab仿真的BPSK_OFDM_Simulation的代码(Simulation using matlab code BPSK_OFDM_Simulation)

of the electrical power system. At the time of transformer energization high current is drawn by the transformer known as the inrush current. This current is nearly ten times more than the full load current of transformer. It produces mechanical stress on transformer and also affects the windings and bushings of the transformer. The large switching transient current affects malfunction of protection system of power system and the different equipments connected to system. So the inrush current should be minimized. There are different methods used to minimize the inrush current such as volt second balance, series compensator, point on wave switching method etc. This paper focuses on point on wave switching method. It also explains the results for inrush current of three phase transformer with and without point on wave switching method. A test is driven on 450 kVA, 500kV/230kV grounded Y/D transformer in MATLAB/SIMLINK environment. It also focuses on

Automata algorithm for image edge detection

matlab 牛顿法迭代,为数值分析课上的作业,用借鉴于其他的迭代计算中.()

matlab 傅里叶展开 波形分解 振动分析(matlab Fourier decomposition on waveform Vibration analysis)