48567941lms_algo

solution for the Statistical modelling for digital signal processing by hayes

实现高维数据向低维数据的转变，降低维数希望群主采纳！(To realize the change of high dimensional data to low dimensional data, reduce the dimension of hope group of main adopted!)

matlab界面编程，适合于界面编程的初学入门。(The introduction to the programmer of matlab.)

编程仿真连续小推力实现GTO到GEO的三阶段转移过程，其中推力器的推力大小为0.8N，轨道机动的起始点为GTO的远地点。GTO轨道的升交点赤经为0度，近地点角距为90度。 GTO轨道： ph:185km，ah：35786km，i：28.5°，GEO轨道：h：35786km，i：0°。 卫星质量为6600kg，从GTO到GEO，采用5000s的推力器。取地球半径为6378km，g取值为9.8m/s^2(The three stage transfer process from GTO to GEO is realized by simulation and continuous small thrust. The thrust of the thruster is 0.8N, and the starting point of orbital maneuver is the apogee of GTO. GTO orbit RAAN is 0 degrees, 90 degrees for the argument of perigee. GTO orbit: ph:185km, ah:35786km, i:28.5, GEO orbit: h:35786km, i:0. The mass of the satellite is 6600kg, from GTO to GEO, using the 5000S thruster. The radius of the earth is 6378km, and the value of G is 9.8m/s^2)

This code is about Independent Component Analysis Or Fast ICA.

generacion de figuras en matlab

改程序主要是针对雷达信号处理中的应用，结合matlab处理(Reform program is mainly aimed at the application of radar signal processing, combined with matlab processing)

说明：  捷联惯性导航的算法，去掉两个参数后的改进算法( The initial alignment of SINS)

dtc 永磁同步电动机的直接转矩控制(dtc )

git 命令图，一张汇总图，详细说明git所有相关命令。(git command graph, a graph to introduce the git command .)