ACCF

OFDM系统经典均衡MATLAB程序, 包括ZF均衡，MMSE均衡，RLS均衡(ZFE ,mmse, rls,for OFDMsystem )

使用改进的遗传算法来优化一维周期稀疏线阵(Using improved genetic algorithm to optimize one-dimensional periodic sparse linear array)

本程序是对V-BLAST系统及其检测算法的仿真，可采用BPSK,QPSK,16QAM,64QAM调制。检测算法为ML，MMSE,ZF,以及采用迫零的连续干扰消除检测算法。(This procedure is a V-BLAST system and its detection algorithm of the simulation, using BPSK, QPSK, 16QAM, 64QAM modulation. Detection algorithm for the ML, MMSE, ZF, and the introduction of zero-forcing successive interference cancellation detection algorithm.)

利用锁相环来实现MSK信号的定时同步，采用的是gardner算法(Using phase-locked loop to achieve timing synchronization of MSK signal, Gardner algorithm is adopted.)

建立无线传感网中节点路由的减少重传次数的一种算法(An algorithm to establish the number of node routing in wireless sensor networks to reduce retransmission)

HC-05蓝牙模块的使用，包括全部参数，外部电路搭建，AT指令等(HC-05 Bluetooth module to use, including all parameters, the external circuit to build, AT commands, etc. )

人工神经网络的工具想函数一览表，可以查询很方便的(artificial neural network tool to the list of functions that can be very convenient inquiry)

说明：  亲测好用的基本的自适应波束形成，LMS和RLS，可以在此基础上改进(Adaptive beamforming, LMS and RLS)

多路复用写的一个可收发数据的串口应用程序(Write a multiplexer can send and receive serial data applications)

利用MATLAB软件对OFDM系统做出仿真。仿真中采用QPSK调制技术，并加入高斯白噪声，最终得到QPSK星座映射图以及BER曲线图。由仿真结果可以看出，OFDM在高斯信道具有良好的抗噪声性能，误码率较低。(MATLAB software is used to simulate the OFDM system. In the simulation, QPSK modulation technology is used, and Gauss white noise is added, and the map of the QPSK constellation and the BER curve are finally obtained. It can be seen from the simulation results that OFDM has good anti noise performance and low error rate in Gauss channel.)