jlink-Pro-v3

基于硬判决的BICM-ID的Turbo均衡及其改进(Hard decision based on the BICM-ID in Turbo equalization and improvement)

超声波测距，ds18b20温度传感器测温度并补偿声速，LCD1602显示温度 距离，还有蜂鸣器报警( Ultrasonic ranging, ds18b20 temperature sensor measures the temperature and compensates the speed of sound, LCD1602 display temperature distance, as well as the buzzer alarm)

说明：  用于单片机的T9键盘中文输入法，可以方便的移植到各种单片机配合lcd工作(T9 Keypad for SCM Chinese input method can be easily ported to a variety of microcontroller work with the lcd)

带参数子程序控制LED闪烁，适合单片机初学者(Subroutine with parameter control LED flashes, suitable for beginners SCM)

– 133 条指令 – 大多数可以在一个时钟周期内完成 　　– 32 x 8 通用工作寄存器 + 外设控制寄存器 　　– 全静态工作 　　– 工作于16 MHz 时性能高达16 MIPS 　　– 只需两个时钟周期的硬件乘法器(--133 Instruction- most can be completed in one cycle- 32 x 8 General Purpose Working Registers+ Peripheral Control Registers- Fully Static Operation- Work performance at 16 MHz up to 16 MIPS- only two clock cycle hardware multiply device)

ads8341采集程序，成功调试通过了。(Ads8341 collection procedures, successful debugging through the.)

主要介绍串联稳压电源原理及主要的应用电路。(Introduces the principle and the main power supply series application circuit)

说明：  图像处理程序,单片机嵌入式,FFT算法(Image processing procedures, single-chip embedded, FFT algorithm)

Arduino 8路串口全双工通信，1个主机与7个从机同时通信。(Arduino Full duplex communication with 8 serial ports.One host communicates with seven slaves at the same time.)

基于PI控制的电力系统静态无功补偿器Simulink仿真，用于验证控制算法的有效性(STATCOM_Base_on_PIcontrol used to verify the effectiveness of the control algorithm It is achieved by Matlab/Simulink.)