2-phase交错PFC 02

HART通用压力变送器的设计压力变送器采用的传感器通常需要不同电路与之配合使用，这就造成产品种类较多，不宜量产。一种崭新的设计思想，设计出的新型电路可以提供软件可控的恒压、恒流输出给传感器，并可以采集两路差分或四路单端输入信号。(HART universal pressure transmitter pressure transmitter used in the design of sensors usually used in conjunction with the different circuits, which result in more product categories, not mass production. A brand new design ideas, to design a new circuit can provide software controlled constant voltage, constant current output to the sensor and can capture two-way differential or four single-ended input signals.)

基于ARM_FPGA的嵌入式数控装置研究，有具体的方案，思路，程序(ARM_FPGA based embedded CNC device research, there are specific programs, ideas, procedures)

模块化的航空发动机模型，可以加入到simulink中(The modular aero engine model can be added to Simulink.)

一篇论文,是关于磁轴承的控制的,用的是经典的PID控制算法.名为<磁力轴承系统PID控制特性的研究>(A paper on the control of magnetic bearings, using a classical PID control algorithm. Entitled )

In higher power applications to utilize the full line power and reduce line current harmonics PFC Pre-regulators are generally required. In these high power applications interleaving PFC stages can reduce inductor volume and reduce input and output capacitor ripple current. This results in smaller overall magnetic volume and filter capacitor volume increasing the converters overall power density. This is made possible through distributing the power over two interleaved boost converters and the inductor ripple current cancellation that occurs with interleaving, reference [5]. This application note will review the design of a 300W two-phase interleaved power factor corrected (PFC) pre-regulator. T

讲述基于定子电流补偿理论的永磁同步电机弱磁控制策略研究(Research on Weak Magnetic Control Strategy of Permanent Magnet Synchronous Motor Based on Stator Current Compensation Theory)

基于USB接口的脉搏检测仪本文设计该检测仪由硬件和软件两部分组成硬件电路包括数采集电路放大滤波电路控制电路及电源电路(ThePulsedetectingInstrumentBasedonUSBInterface)

osgocean的经典论文，讲了光照的折射反射，海浪频谱以及水下的光照问题等。(osgocean classic paper, about the reflection of light refraction, the wave spectrum and underwater lighting problems.)

这个是我2006年的毕业设计，从理论到伺服电机的位置控制实现，我一个人用了4个月的时间来搞，现在把整篇论文和程序都上传到这里来，希望可以对初学电机驱动的朋友有帮助。(This is my 2006, graduation design, from theory to the servo motor position control, a person I used 4 months time to do, now the entire papers and procedures are uploaded here, hope can be for beginners motor drive has to help a friend. )

说明：  基于USB的数字接口测试系统的设计，硕士学位论文(USB digital interface based on test system design, Master thesis)