ZF_SIC

图形界面实现MQTT通信协议的演示例子程序。(This is an MQTT GUI Demo application,to show how to progrrame with MQTT.)

美国佛罗里达大学Li Jian教授关于MIMO Radar的经典讲义，从事该领域研究的不得不看啊(Li Jian professor at the University of Florida on MIMO Radar classic lectures, engaged in research in this field have to see ah)

103转modbus协议C程序，支持多个485端口并能够配置(103 turn modbus protocol C program, more than 485 ports and supports the ability to configure)

实现通信系统的数字模拟混合预编码，进行干扰抑制，提高系统性能，降低硬件复杂度和实现成本(The digital analog hybrid precoding of the communication system is realized, the interference suppression, the performance of the system, the complexity of hardware and the cost of realizing the system are reduced.)

用的Rsoft软件 模拟了两个矩形直波导的耦合情况，并监测其功率变化。 可用于分析微环耦合区域的光场。(Rsoft software used to simulate the two rectangular straight waveguide coupling, and to monitor their power change. Can be used to analyze micro-ring coupling region of the light field.)

非常有用的非平稳信号分析工具箱，对非平稳信号参数估计很有帮助。(Useful non-stationary signal analysis toolbox, non-stationary signal parameters estimated helpful.)

LDPC码不同译码算法对比。码长512，码率1/2.(LDPC code decoding algorithm comparison. Code length of 512, a rate 1/2.)

说明：  STC单片机多机连级串口程序可实现.416路控制. 串口和485都可以使用、 一个程序可以用在26块控制板上，通过拔码开关给板子编号，每块板可以过滤分析所接收到不同的代码。进行继电器的动作，能返回数据，因使用定时器发送返回，不会阻塞或者代码错乱、可以 用在中控，物联网，等各种控制场合。修改代码后，能达到上千路的控制。(STC single-chip microcomputer multi-level serial port program can realize 416 channel control. Serial port and 485 can be used. One program can be used on 26 control boards. Each board can filter and analyze different codes received by numbering the boards with the pull-out switch. Relay operation can return data, because the timer is used to send the return, it will not block or code confusion, and can be used in central control, Internet of things, and other control occasions. After modifying the code, it can achieve thousands of control.)

16QAM调制解调，包含QAM的调制解调Matlab程序(16QAM modem, including QAM modem matlab program)

微机之间串口通信,实现两台微型计算机之间快速简便的串行通信,()