Li-Jian-MIMO-Radar

在MATLAB中用Goertzel算法（先用FFT算法，再用goertzel算法，）仿真DTMF的产生与检测的程序。应用于双音多频信号的产生与检测。(in Goertzel algorithm using MATLAB (first using FFT algorithm, reuse goertzel algorithm) simulation DTMF detection with the selection process. Used DTMF signal detection with the selection.)

卫星信道信道估计的matlab仿真程序，对不同的插值算法给出比较输出并画出误码率-信噪比曲线(Satellite channel channel estimation matlab simulation program, different interpolation algorithms and draw the comparison output is given BER- SNR curve)

PMA规约模拟测试软件。适合初学者使用，包含几个常用规约(PMA Statute of the simulation test software)

感觉这份代码中最有价值的应该是水声信道的建模，该源码来自美国 Parastoo Qarabaqi, Northeastern University, 2013其次其提供了基于l1范数下PCA处理算法，来对经由水声信道的信号进行处理给出误码率图，启动比较程序需要先使用信道生成函数对信号进行生成。(The most valuable part of this code is the modeling of underwater acoustic channel. Secondly, it provides a PCA processing algorithm based on L1 norm to process the signals passing through the underwater acoustic channel and gives a bit error rate chart. To start the comparison program, the channel generating function is needed to generate the signals first.)

说明：  空域零陷，首先用doa技术估计直达波方向，然后置零，用于直达波消除。(In spatial nulling, DOA technique is used to estimate the direction of direct wave, and then zeroing is used to eliminate direct wave.)

说明：  利用叠加法pm谱，生成三维海浪波形的源程序，输入风级数，频率数和角度数得到该风级下的海浪波形；(Using the superposition method PM spectrum, the source program of three-dimensional wave waveform is generated, and the wave waveform under the wind level is obtained by inputting the number of wind level, frequency and angle;)

信号分析仪 编程手册主要是基于安捷伦IO 套件应用平台 简单实用的仪器控制编程程序(Signal analyzer e5052a programming manual is mainly based on agilent IO suite application platform Simple and practical instrument control programming procedures)

通过单片机读取sht3x高精度温湿度传感器程序(Read sht3x high precision temperature and humidity sensor program through MCU)

因为TWAIN的协议比较复杂,该程序,为你展示了TWAIN的使用(because the agreement is more complicated, the procedures for the display you use the TWAIN)

cooperative relay communication ieee