ch2

DSPAlgorithms:Algorithm Collections for Digital Signal Processing Applications using Matlab .i think it will help the coders

it s about beamforming

说明：  finds polynomials using spline algorithm

radar problems and solutions

将广义预测控制与NMM模型相结合，并与其它各种控制方法比较(The generalized predictive control is combined with the NMM model and compared with other control methods)

能实现人脸的简单匹配算法，本人亲自测试，还行吧(To achieve a simple matching algorithm, face, OK.)

ChannelDistoration.m实现了相同的数字信号分别经过无失真信道、幅度失真信道、相位失真信道和幅、相失真信道时的输出信号畸变情况。(ChannelDistoration.m realized through the same digital signals without distortion channel, amplitude distortion channel, the channel phase and amplitude distortion, phase distortion of the output signal of the channel when the aberration.)

主要包括一个测试数据集合mydata.mat,main.m，DBSCAN.m和PlotClusterinResult.m共4个文件，我们在测试实验实验中做了两个方面更改：1)更换了另外一个测试数据，测试数据来源于[13]（取其中的一部分）,2)添加了个K距离图部分代码(均在如下主程序代码中给出)，代码按照个人对k-distance graph的理解编写，如有错误之处，望大家指正，3）改变参数Eps值大小，输出结果并显示。(Including a test data set mydata.mat, main.m, DBSCAN.m and PlotClusterinResult.m, a total of 4 documents, we do two aspects of change in the experimental test: 1) to replace another test data, test data from [13] (part of the), 2) add a K distance map the code (both in the main program code are given in the following), according to the personal understanding of the k-distance graph code written, if wrong, hope you correct me, 3) value to change the parameters of Eps, output and display.)

為jacobi與gauss seidal迭代法 只要把A,b,N更換成你要的即可(To jacobi and gauss seidal iterative method as long as the A, b, N you want to replace)

说明：  针对铣削过程建立的动力学方程，推导出可用以指导加工的稳定性叶瓣图，获得各主轴转速下对应的极限切深。(According to the dynamic equation of milling process, the stable lobe diagram which can be used to guide machining is derived, and the corresponding limit cutting depth of each spindle speed is obtained.)