登录
首页 » C# » PIC16F73

PIC16F73

于 2015-12-16 发布 文件大小:413KB
0 177
下载积分: 1 下载次数: 16

代码说明:

  PIC16F73做的逆变器程序及原理图,k可以根据资料直接做出来小功率逆变器(PIC16F73 do inverter program and schematic, k can be done directly out of the small power inverter according to information)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • zhinengdengguang
    单片机时控光控系统,智能灯光控制,定时开关灯光,光感应开关灯光(Single-chip microcomputer control light-control system, intelligent lighting control, time switch lights, lights light induction switch)
    2020-06-29 20:00:01下载
    积分:1
  • A-fuzzy-expert-system-for-loss-reduction-and-volt
    A fuzzy expert system for loss reduction and voltage control in radial distribution systems
    2016-07-06 15:15:32下载
    积分:1
  • armboot
    基于ARM的芯片多数为复杂的片上系统,这种复杂系统里的多数硬件模块都是可配置的,需要由软件来设置其需要的工作状态。因此在用户的应用程序之前,需要由专门的一段代码来完成对系统的初始化。(ARM-based chips, most of the complex system on chip, where the majority of this complex system can be configured hardware modules are required by the software to set up the working status of their needs. Therefore, the application before the user needs from the special section of code to complete the initialization of the system.)
    2010-05-13 20:38:18下载
    积分:1
  • LPC_1768LCD(1298)
    LPC1768的学习资料,资料包括原理图,源码(LPC1768 learning materials, including schematics, source code)
    2015-08-08 10:35:05下载
    积分:1
  • Fingerprint_Recognition_Systemm
    its all about the finger print recognition
    2010-02-09 04:04:31下载
    积分:1
  • zhaobo
    基于pscad仿真的升压斩波控制,利用PWM实现(failed to translate)
    2021-04-25 18:08:46下载
    积分:1
  • Dynamic-digital-tube-display
    动态数码管显示程序,这个应该没有什么好解释的吧@!(Dynamic digital tube display program, this should be no good explanation!)
    2012-07-28 21:15:24下载
    积分:1
  • 基于stm32对ads1298进行读取 v1.4
    基于stm32对ads1298进行读取,用于心电前端采集(Based on ads1298 stm32 read, front-end for ECG acquisition)
    2015-03-18 15:00:02下载
    积分:1
  • STM32F103-DAC
    在STM32上实现片内DAC模块的模数转换功能(Realization of analog-to-digital conversion)
    2020-07-01 17:20:02下载
    积分:1
  • Timer_key_1602
    说明:  利用MSP430单片机实现5分钟倒计时。用Timer_A实现1s定时,4位共阳型数码管显示时间,显示格式为:“x-xx”,分别代表“分”、“十秒”和“秒”。每隔1s,倒计时器的时间减1,倒计时从4分59秒开始计时,至0分0秒结束,停止计时。(MSP430 microcontroller is used to realize 5 minute countdown. Timer_A is used to realize 1s timing and 4-bit common-sun digital tube display time. The display format is "x-x x", representing "minutes", "ten seconds" and "seconds" respectively. Every 1s, the countdown time is reduced by 1. The countdown time starts at 4:59 seconds and ends at 0:0 seconds.)
    2019-04-08 20:51:10下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载