GP

说明：  信号时序幅频仿真图(timing signal amplitude and frequency simulation map)

大规模MIMO中，有关于能效的相关文章 (MASSIVE mimo energy efficiency )

合成孔径雷达成像程序，使用CS算法，对点目标进行仿真，实现点目标的成像(Synthetic aperture radar imaging procedures, the use of CS algorithm, the point target simulation to achieve point target imaging)

利用线性矩阵不等式编写的可行解求解程序，可以看一下了。(LMI simulation)

注水算法是根据某种准则，并根据信道状况对发送功率进行自适应分配，通常是信道状况好的时刻，多分配功率，信道差的时候，少分配功率，从而最大化传输速率。本文运用matlab通过对注水算法在mino系统中的三种不同的情况下进行了仿真，比较出在小信噪比时，相同信噪比下利用CSI的功率注水算法获得容量优于未知CSI的平均功率分配算法；相同容量下已知CSI信噪比比未知CSI时的信噪比小3dB.当信噪比增大到一定程度时，功率注水算法所获得的信道容量将收敛到平均功率分配的信道容量。(Water flooding algorithm is based on certain standards, and according to the channel condition to adaptive allocation of sending power, usually is a good moment, channel situation more distribution power, channel is poor, less power distribution, so as to maximize the transmission rate. This paper USES matlab based on water flooding algorithm in Austin system of three different cases are simulated and compared in small SNR, under the same SNR use CSI power allocation algorithm for capacity is superior to the average power allocation algorithm of unknown CSI Same capacity known CSI signal-to-noise ratio than the unknown CSI small signal-to-noise ratio of 3 db. When the signal-to-noise ratio increases to a certain degree, the power allocation algorithm for channel capacity will converge to the average power distribution channel capacity. )

KMV编程代码，很实用的，把数据代进去就行了鸭(KMV programming code, very practical, put the data in place on the duck.)

利用卡尔曼滤波器进行信道估计 提示：信道估计的状态方程和测量方程可分别表示为 要求：给出信道均方误差随样本数增加的曲线，给出matlab程序及具体的估计过程。 (Use of Kalman filter channel estimation Tip: the state of the channel estimation and measurement equations could be specified as required: given the channel mean square error increases with the number of samples to increase the curve, given the estimated matlab program and the specific process.)

风向驾驶模型,让驾驶员在驾驶过程中遇到的风速进行仿真。(Wind driving model, so that the driver in driving wind encountered during simulation.)

dijkstra_GUI应用实例，选择起讫点，在图形界面显示最短路径。。。(example of dijkstra_GUI)

一个用matlab编写的关于图像处理中的灰度化和二值化。(A prepared using matlab image processing on grayscale and binary.)