full_bridge_rectifier

设计报告和设计方案，相信对参加飞思卡尔竞赛的有帮助。(The design report and design plan are believed to be helpful for participating in the Freescale Competition.)

基于OLED STM32F103 SPI基本驱动程序(Based on OLED STM32F103 SPI basic driver)

在许多的单片机应用系统中，都需要A/D转换器，将模拟量转换成数字量。在STM8单片机中，提供的是10位的A/D，通道数随芯片不同而不同，少的有4个通道，多的则有16个通道。 下面的实验程序首先对A/D输入进行采样，然后将采样结果的高8位（丢弃最低的2位），作为延时参数去调用延时子程序，然后再去驱动LED控制信号。因此不同的采样值，决定了LED的闪烁频率。当旋转ST三合一开发板上的电位器时，可以看到LED的闪烁频率发生变化。 (In many microcontroller applications require the A/D converter to convert analog into digital. STM8 microcontroller, providing a 10-bit A/D channel number with the chip, little has four channels, more than 16 channels. The following experimental procedure first sampling A/D input, then the sampling results 8 (drop the lowest 2), as the delay parameter to call the delay subroutine, and then go drive LED control signal. Different sampling values, the LED flashing frequency. When the potentiometer rotation ST triple development board, you can see the LED flashing frequency change.)

labview倒立摆上位机程序，是2013年9月分全国电子设计大赛的作品，但是可惜的是，电子大赛不能用电脑，很遗憾，发上来让大家参考，写的不好，希望多包涵(labview handstand put crew procedures, 2013 September, 2011 National Design Competition works, but unfortunately, can not use a computer electronic contest, unfortunately, made up for our reference, badly written, I hope more than covered)

SSD6 EXAM PRACTICAL TASK

单片机初学者资料 51单片机C语言编程入门(详讲版)(Singlechip beginners )

根据太阳电池量子效率曲线计算光短路电流密度(calculate the short current density according to the quantum efficiency curve of solar cell)

用飞思卡尔HS12系列单片机生成的定时程序，使用MDC方式作为定时器(Freescale HS12 Series MCU with the generated timing procedures, using the MDC as a means to the timer)

编写一段程序 统计从1000年到1999年之间闰年的个数 最后输出到屏幕上来(writing a program to sum up the numbers of leapyear between 1000 and 1999.Finally,showing the result on the screen.)

用程控放大器MCP6S26对信号进行增益放大，并用显示屏显示出来。(With a programmable gain amplifier MCP6S26 the signal amplification, and displayed by the display.)