pso_fcm

数值分析的非线性方程组的解法，工具使用的是matlab，很简单但很实用。(Numerical analysis of nonlinear equations, solution, tool use matlab, very simple but very practical.)

MathLab introduction in Romanian.

粒子滤波实例，讲述如何利用粒子滤波算法对视频滤波(Particle Filter)

说明：  在阵列信号处理中,可以对信号的来波方向进行估计,并计算其估计误差!(In array signal processing, the signal can be estimated to wave direction, and calculate the estimation error!)

overlapped image segmentation the code can also be found at matlabcentral

PESQ measure: ------------- Usage of the PESQ objective measure is as follows: [pesq_mos]=pesq(cleanfile.wav,enhanced.wav) where cleanfile.wav contains the clean speech file and enhanced.wav contains the enhanced file.

摘要 本文提出了一种新的基于极大似然法的椒盐噪声滤波算法。在传统BP 算法中引入 了极大似然估计，在训练样本时能够在考虑网络逼近行为的同时对噪声分布进行估计。而且 针对椒盐噪声模型构造了新的鲁棒误差函数，从而使算法本身的抗干扰性增强。实验结果表 明了该算法与传统BP 算法相比具有更好的滤波性能。(Abstract This paper presents a new maximum likelihood method based on impulse noise filter. In the traditional BP algorithm, the introduction of the maximum likelihood estimation, the training samples can also be considered acts of the network approach to estimate the noise distribution. Salt and pepper noise and model construction for a new robust error function, so that the enhanced anti-jamming algorithm itself. Experimental results show that the algorithm compared with the traditional BP algorithm has better filtering performance.)

Simulink model for closed step change in inverter.

说明：  一些有关最优控制理论的控制实例程序集和仿真 (Control instance assembly of the optimal control theory and simulation)

潮流计算是电力学名词，指在给定电力系统网络拓扑、元件参数和发电、负荷参量条件下，计算有功功率、无功功率及电压在电力网中的分布。潮流计算是根据给定的电网结构、参数和发电机、负荷等元件的运行条件，确定电力系统各部分稳态运行状态参数的计算。通常给定的运行条件有系统中各电源和负荷点的功率、枢纽点电压、平衡点的电压和相位角。待求的运行状态参量包括电网各母线节点的电压幅值和相角，以及各支路的功率分布、网络的功率损耗等。(Power flow calculation is a term of power science. It refers to the calculation of the distribution of active power, reactive power and voltage in power network under given network topology, component parameters and generation and load parameters. Power flow calculation is based on the given grid structure, parameters and operation conditions of generator, load and other components to determine the steady-state operation parameters of each part of the power system. Usually, the given operating conditions include the power of each power source and load point, junction voltage, balance point voltage and phase angle. The parameters to be determined include the voltage amplitude and phase angle of each bus node, the power distribution of each branch and the power loss of the network.)