matlab

stap 空时自适应信号处理仿真程序，主要仿真杂波协方差矩阵，改善因子(stap)

基于MATLAB的GPS选星分析及实验研究(MATLAB-based analysis of the GPS satellite selection and Experimental Research)

小波去噪程序，根据信号的频域特征对信号进行小波分解，然后去噪(program for artifact removal, this function is obtained based on the frequency feature of signal.)

Solving Non linear Schrodinger Equation in Optical Communication

同步电机模型的MATLAB仿真，全篇论文，包括相关仿真。(MATLAB simulation of synchronous machine model, this thesis, including the related simulation.)

基于AIC方法用MATLAB估计信源个数的程序 ( estimate the singal source number using AIC)

基于直方图最大熵的目标提取算法，打包文件里含有完整的matlab程序，还有运行时的标准图片(Histogram extraction algorithm based on maximum entropy objective, packed file contains the complete matlab procedures, standards, as well as run-time images)

验证傅里叶切片定理，可减少傅里叶变换的计算量(fourier slice)

多目标粒子群算法，模拟传感器布置的，又需要的小盆友可以过来拿(MOPSO algorithm)

1. 基于simulink搭建一个QPSK发送链路，QPSK调制信号经过了瑞利衰落信道，观察信号经过衰落前后的星座图，观察信道特性。仿真参数：信源比特速率为500kbps，多径相对时延为[0 4e-06 8e-06 1.2e-05]秒，相对平均功率为[0 -3 -6 -9]dB，最大多普勒频移为200Hz。(1. Based on simulink structures, QPSK sent a link, the Rayleigh fading channel after the QPSK modulation signal, were observed before and after signal after the decline of constellation diagram, observation channel characteristic. Simulation parameters: the source is 500 KBPS bit rate, relative multipath time delay of [0 8 e 4 e- 06-06 e-05] 1.2 seconds, the relative average power is [0-3-6-9] dB, most of the doppler frequency shift is 200 hz.)