yinyue

液晶240*128驱动 用的是PIC单片机 但是可以改 51单片机 里面驱动都一样 就是 拿过来就可以用 (LCD 240* 128 drive using a PIC microcontroller, but can be changed inside the microcomputer 51 is to take over the same driver can be used)

基于msp430f2618的lcd的液晶图形显示程序(Based on msp430f2618 the lcd LCD graphics display program)

NTC热敏电阻计算器（B值、R25、指定温度、指定阻值均可计算，给定四个参数即可计算第五个参数）(NTC thermistors Calculator (B value, R25, specified temperature, the resistance can be specified calculation, four parameters can be calculated given the fifth parameter))

QuizMaster for viusal basic.

51单片机温度采集与显示设计 - 通过DS18B20温度传感器获取温度,并通过数码管显示,并实现了温度可手动校准(51 single-chip temperature acquisition and display design- through DS18B20 temperature sensor for temperature, and through the digital display, and achieve a temperature can be manually calibrated)

该C语言例程为AM波，DSB波调幅程序，适用于单片机等等。(The C language routines for the AM wave, DSB wave amplitude modulation procedures, for single-chip and so on.)

智能追踪小车，并且可以用遥控手动控制转弯加前后左右(Intelligent tracking car, and can be controlled manually with the remote turn around Canada)

高压直流输电模型，二百二十千伏的，有参考价值，做的挺不错(HVDC model, $ 220 kV, a reference value, doing pretty good)

使用方法： 程序设置了ENC28J60的IP为192.168.0.15，模块通电后与电脑的网口用网线连接起来， 设置电脑的本地IP为192.168.0.**（**自定），网关为192.168.0.15,其他默认，配置 成功后便可以arp或ping模块。 打开浏览器，在地址里输入http://192.168.0.15/123456可打开开发板简单网页，页 面上通过按键来控制开发板LED的亮灭。(Use: setup the ENC28J60 of IP to 192.168.0.15, the module is powered on the computer' s Ethernet port using a cable connection up to set the computer' s local IP 192.168.0.** (** Custom), the gateway 192.168.0.15, default configuration is successful, it will make arp or ping module. Open the browser, enter the address http://192.168.0.15/123456 to open the development board simple web pages, and page keys to control the development board LED light off.)

这是利用51单片机设计成的8路抢答器,主持人按下“开始”按键才开始抢答，并亮抢答允许指示灯(Host press the start button to vies to answer first, light and bright vies to answer first allowed.)