wind_dfig

该程序用matlab仿真了OFDM下行链路的资源分配，包括功率和比特分配、子载波分配(The program matlab simulation the OFDM downside link distribution of resources, including power and bit allocation, the subcarrier allocation )

说明：  MATLAB GUI上位机，WiFI通信，连接稳定，可同时采集四个通道的数据，互不干扰(Matlab GUI upper computer, WiFi communication, stable connection, can collect data of four channels at the same time, without mutual interference)

通过MATLAB程序可以很容易的画出三维的图像，让初学者一目了然。(MATLAB program can easily draw a three-dimensional image, so that beginners at a glance.)

simulink搭建滑模观测器，并检测出故障，对故障鲁棒，具有较好的检测效果。(Simlink builds sliding mode observer and detects faults. It is robust to faults and has good detection effect.)

lte上行链路，生成发送端的pucch信道信息，包括符号以及导频序列，pucch格式为1b，开发环境为ccs3.3(lte uplink, the sender s pucch channel and pilot symbol sequence generation, format 1b)

Channel estimation for a MIMO-OFDM system for AWGN channel estimation technique Cyclic prefix length

GPS整周模糊度降相关调整算法，是动态载波相位测量的经典算法，内附PDF文档详细介绍了MATLAB子程序功能。(solution for GPS integer ambiguity ,is classic algrithom for carrier mearsurement RTK,including the instruction for matlab program)

这是一个matlab和optisystem联合调试用的误码率计算程序，里面的文件报过一个可以用optisystem7和optisystem13可以打开的OSD仿真图，还有一个MATLAB计算BER的程序。给出了如何设置系统的大纲。从OptiSystem的电信号输入到Matlab组件。当OptiSystem运行时，它将调用Matlab组件中的M文件，处理数据，然后将所得的电信号导出回OptiSystem。然后将输出信号连接到BER分析仪。经过我调试，文件齐全，放心下载(The attached image gives an outline of how the system should be setup. You should start with inputting the electrical signal from OptiSystem into a Matlab component. When OptiSystem runs, it will call the M-file in the Matlab component, process the data, and then export the resulting electrical signal back into OptiSystem.The output signal is then connected to the BER Analyzer.)

gps静态单点定位,使用kalman滤波算法,导航定位精度好.(gps static single-point positioning, navigation and positioning accuracy using kalman filtering algorithm.)

洗澡水温模糊调节系统仿真结构，结构简单易懂，附有fis文件。(Fuzzy control system of bath water temperature simulation structure, structure is easy to understand, with fis file.)