lfm_jc

这是一个关于齿轮的齿顶圆和齿根圆半径的计算程序，先将图片预处理和二值化，然后进行边缘检测求出圆心，最后用平均法求出半径。(This is an addendum on the gear tooth root radius circle and the calculation procedure, the first image preprocessing and binarization, edge detection and then find the center of a circle, with the final calculated average radius.)

pwm Igbt model in matlab simulink

关于维纳滤波器、卡尔曼滤波器、自适应滤波器的设计方法，及信号提取、分析。(On the Wiener filter, Kalman filter, adaptive filter design method, and signal extraction, analysis.)

homework 3-3 is difficult

ADRC即自抗扰控制器的matlab仿真程序，包括离散法求输出和龙格库塔法求输出两个M文件。已编译过，参数调好了。(ADRC since the anti-rejection controller matlab simulation program, including the discrete method for the output and the Runge-Kutta method seeking output two M-files. Has been compiled, the parameters of a good tune.)

1.将BMP图像内容读入内存数组。 2. 调整图像的灰度，对图像进行灰度变换（反变换）。 3. 对图像进行较正,分别取值为0.4,0.6,0.8.(1. The BMP image content is read into memory array. 2 Adjust the gray image, the image gray-scale transformation (inverse transform). 3 more positive image, respectively, the value of 0.4,0.6,0.8.)

地震资料处理中一些简单的操作，绘图程序等。(seismic data processing)

matlab实现的电子稳像算，经过调试，能够正确运行！(matlab realize electronic image stabilization count, after commissioning, to run properly!)

说明：  希望每一个使用本程序的人都能做到保密，因为这里的许多东西都是相当宝贵的，如果还有别的需要可以单独发邮件给我(hope every one use of the procedures people can be kept confidential, because many things here are very valuable, if there are other needs alone can send an email to)

模式分类的matlab程序，十二五规划模式识别导论教材答案( Pattern classification matlab procedures, Twelfth Five Year Plan Introduction textbook answer pattern recognition)