1602PAD

NTC测温程序的查表方法--经典的二分法。(NTC thermistor temperature measurement program)

单片机AD功能实例，使用1602显示电压(SCM AD function example, the use of 1602 shows the voltage)

一个能读取DHT11湿度传感器的程序，使用STM8S003K3P6(A program to read DHT11 humidity sensor)

用138,595控制的点阵，附带两个不同控制方式的源程序以及电路连接图，(With 138,595 dot control, with two different control modes of the source and a circuit connection diagram,)

PIC Microcontroller project Door lock with PIC16f84a

说明：  用mcs-52系列单片机实现等精度频率测量，T1引脚接被测TTL信号，晶振22.1184MHz，对任何频率都可以实现很高精度的测量（精度<1 )，结果从串口字符串输出，波特率115200，可以用串口调试器观察结果.(With mcs-52 family of single chip and other precision frequency measurement, T1 pin then measured TTL signal, Crystal 22.1184MHz, any frequency can be achieved very high accuracy of measurement (precision<1 ), the result string from the serial output , baud rate 115200, serial debugger can observe the results.)

stepper motor example with proteus

TIF2801的modbus协议程序，带仿真函数(Modbus for TIF2801)

HCS08的AD例程：本程序是ADC模块的例程，所用资源为单片机内部ADC转换模块， 所接器件为电位器.(HCS08 s AD routine: This is the ADC module of the routine procedure, the use of resources within the ADC conversion for the microcontroller module, the device is connected potentiometer.)

说明：  基于51单片机红外遥控智能小车（原理图、PCB、遥控器控制程序、实物图）(ntelligent car based on 51 microcontroller infrared remote control (schematic diagram, PCB, remote control program, physical map).)