Probabilistic-Neural-Network-

很好的OFDM的基于MATLAB的仿真程序包，且包含了最终结果图.(montecarlo type montecarlo in the command window and wait for a long time.. _simulation of the complete OFDM system. _use of a very large file in order to get probabilities. _loop over different value of the noise. _compute the SNR for each value of the noise. _provide the SNR/BER plot. if you are in a rush : simulation_system !! go into the right folder and type simulation_system in the command window. _then type the value of the noise power (range = [-20,10]) _the function provides the channel estimation, the bit allocation, and a plot illustrating the errors. _this is a fast function (less pilot, no synchronization, small file).)

基于MATLAB中对于风电场的模型及仿真(Based on MATLAB, the wind farm model and simulation)

程序代码说明 P0401：用Prewitt算子检测图像的边缘 P0402：用不同σ值的LoG算子检测图像的边缘 P0403：用Canny算子检测图像的边缘 P0404：图像的阈值分割 P0405：用水线阈值法分割图像 P0406：对矩阵进行四叉树分解 P0407：将图像分为文字和非文字的两个类别 P0408：形态学梯度检测二值图像的边缘 P0409：形态学实例——从PCB图像中删除所有电流线，仅保留芯片对象(Procedure Code Description P0401: detection using Prewitt operator Edge P0402: σ values with different operator LoG edge detection image P0403: detection using Canny operator Edge P0404: Image Thresholding P0405: thresholds for water line image segmentation method P0406: for the matrix decomposition quadtree P0407: text and images are divided into two categories of non-text P0408: detection of morphological gradient of the edge binary image P0409: morphological examples- from the PCB to remove all images current lines, retaining only the target chip)

test car lane changing with matlab simulink based on fuzzy control test 4.

基于matlab中的simulink的pcm编码解码器的仿真结果(Simulink in matlab based on the pcm codec simulation results)

基于matlab仿真平台的scfdma的仿真代码(Matlab simulation platform based on the simulation code scfdma)

差分进化算法的简单实例，快速易懂，方便使用(failed to translate)

说明：  MATLAB 的使用说明，应该会对大家有很多帮助的，欢迎下载(MATLAB' s instructions, should we have a lot of help will be welcome to download)

有限元数值计算的源程序，matlab实现的(FEM calculation of the source, the realization of Matlab)

本代码是关于用matlab算出两路信号的相位差(the code is calculated on the use of Matlab two signals phase difference)