target-tracking-in-three-dimensional

采用加权网络中节点强度和权重都是幂率分布的模型，GPS和INS组合导航程序，做视觉测量的上位机代码。( Using weighted model nodes in the network strength and weight are power law distribution, GPS and INS navigation program, Do Vision Measurement PC code.)

comparaison of photovoltaic mppt algorithms

极化敏感阵列的学习笔记，有助于了解极化敏感阵列的相关知识(Study notes polarization sensitive array, helping to understand the polarization sensitive array of relevant knowledge)

协作通信中译码转发方式DF协作方式实验仿真主程序。(DF collaborative experiment simulation main program)

TCPIP协议详解卷三：事务TCPIP协议详解卷三：事务TCPIP协议详解卷三：事务(TCPIP protocol Xiangjie Makizo: Services TCPIP protocol Xiangjie Makizo: Services TCPIP protocol Xiangjie Makizo: Services)

采用滤波器组，将盲分离与声源定位结合在一起。滤波器组中分别进行子带处理，并且在每个子带中进行声源定位，最后综合所有子带估计的方向得到多个声源的方位信息，同时将声源信息作为ICA分析的约束条件，可以在色噪声及多得到更好的盲分离效果。其优势在于用滤波器组进行多次的估计声源方向，再加以合适的权值均衡后即可得到更优的估计。(The use of filters will be blind source separation and sound localization together. Filter group were sub-band treatment, and in each sub-band in Sound Source Localization, and finally all the sub-band is estimated to be more than the direction of sound source location information, as well as sound source information as ICA analysis of the binding conditions, colored noise can be better and many of the blind source separation effect. Its advantage lies in a number of filter banks with estimated sound source direction, coupled with an appropriate balance weights can be obtained after the better estimate.)

利用matlab simulink产生两路模拟语音信号，经过pcm编码、时分复用、DPSK调制经过同一个信道单向传输到对应的接收端。常用的三个模块 simulink、通信模块、信号处理模块。包括课程设计报告。(Using matlab simulink produce two analog voice signals through the pcm encoding, time division multiplexing, DPSK modulation over the same one-way transmission channel to a corresponding receiver. The three modules used simulink, communication module, a signal processing module. Including curriculum design report.)

本章介绍了用于WAN(广域网)环境的各种协议和技术。在这里概述的题目包括点对点链路，电路交换，分组包交换，虚电路，拨号服务，和WAN设备。在手册第3部分,‘WAN协议’,的各章里将更详细地讲述专门技术。 ( This article introduces the various protocols and technologies used in wide-area network (WAN) environments. Topics summarized here include point-to-point links, circuit switching, packet switching, virtual circuits, dialup services, and WAN devices. Chapters in Part 3, “WAN Protocols,” address specific technologies in more detail. )

争对移动声源采用波束形成进行语音增强，提出一种约束子带波束形成算法。其波束形成器基于一个软约束，其目的是要使波束指向特定的区域即声源方向。而其核心在于首先要进行声源定位，获得尽量准确的方位信息，然后构造软约束条件，用于波束形成。且在此过程中不断跟踪声源的移动情况。在构造的约束条件中，需要知道声源的二维信息，即与麦克风阵列的距离和方向角，“软”体现在对距离和方向角的确定都是在一定范围内的，有待进一步更正。(Between the mobile sound source using beamforming for speech enhancement, a constrained subband beamforming algorithm. Its beamformer based on a soft constraints, the aim is to make the beam point to a specific region that is the direction of the sound source. And its core is the first to sound source location, access to location information as accurately as possible, and then construct the conditions of soft constraints for beamforming. And in the process continuously tracking the movement of a sound source. Structure at the binding conditions, need to know the two-dimensional sound source information, that is, with the microphone array the distance and direction angle, the " soft" embodied in the distance and direction angle of the determination are within the scope must be further corrected .)

convergence behaviour of distance vector and link state routing protocols